707345
7
Zoom out
Zoom in
Previous page
1/33
Next page
Preparing to Play
7
Preparing to Play
Using the AC adapter
1.
Make sure that the power on this instrument is turned o.
2.
Connect the DC plug of the included AC adapter to the
DC 12V jack located on the rear panel of the EK‑50.
Be sure to use only the included AC adapter. Using any
other AC adapter may cause malfunctions.
Hook the AC adapter cord onto the cord hook. Do not use
excessive force when pulling the cord o the hook.
Cord hook
AC adapter (included)
When hooking the cord onto
the cord hook, be careful not
to bend this part any more
than necessary.
3.
Connect the plug of the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for
your adapter.
Using this instrument with batteries
You can use eight AA alkaline or nickel‑metal hydride baeries
to power this instrument.
Zinc‑carbon baeries cannot be used.
Note:
Baeries are not included, so please obtain them
separately.
Installing batteries
1.
Make sure that the power on this instrument is turned o.
2.
Push the two tabs on the baery compartment cover that is
located on the boom of this instrument to open the cover.
Note:
When turning the
instrument upside down,
place it on a blanket or similar
material to prevent damage to
the display, joystick and so on.
3.
When inserting the baeries,
be sure to observe the correct polarity (“+” and “–”).
Do not mix new and old
baeries, or baeries of dierent
types. Failing to observe this
guideline might cause the
baeries to leak or burst.
4.
Close the baery cover.
Note:
To make sure the correct
baery level is displayed, make the seing on this instrument
for the type of baery you are using (see page 21 “Seing the
baery type”).
Replacing the batteries
The baery indicator is displayed at the top right‑hand part of
the display.
Note:
This indicator will not be displayed while the AC adapter
is plugged in.
When the indicator is blinking, this means that the baeries are
nearly depleted, so replace the baeries as soon as possible or
connect an AC adapter to power this instrument.
Remove depleted baeries immediately. Leaving depleted
baeries in could result in malfunctions caused by baery
electrolyte leakage or similar problems. Also, remove the
baeries if you will not be using the EK‑50 for a long time.
Turning the power on/o
1.
Turn the VOLUME knob all the way to the left, so that the
volume is down.
2.
Press the power buon to turn the instrument on.
When turning o the power, hold the power buon down
until the backlight on the display goes dark.
Note:
The EK‑50 will automatically turn o if it has not been
played or operated for a certain amount of time (via the auto
power‑o function).
The time interval is set to 30 minutes at factory default. This
interval can be changed (see page 21 “Changing the auto
power‑o function”).
1
2
7


Need help? Post your question in this forum.

Forumrules
1

Forum

korg-ek-50

Reset search

  • My grand piano has no volume and the ‘keyboard set’ is flashing Submitted on 10-6-2021 at 12:22

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Korg EK-50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Korg EK-50 in the language / languages: English as an attachment in your email.

The manual is 3,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Korg EK-50

Korg EK-50 Quick start guide - English - 76 pages

Korg EK-50 User Manual - German - 33 pages

Korg EK-50 Quick start guide - German, French, Spanish - 76 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info