Operation:
1. Connect the transmitter with the AV cable with the output of VCR, DVD or
SAT.
2. Connect the receiver with the AV cable with the input of TV, LCD screen or
PLASMA.
3. Connect the plug of the 7.5V DC adapter into the transmitter and the
receiver and connect the power plug into a 230 Volt wall outlet. Note: use
the provided adapters only.
4. Select on the transmitter and receiver the desired channel with the channel
switch. In case of possible distortion on a channel in picture and sound try
another channel. For optimum performance, it could be necessary to point
the transmitter and receiver to eachother in an imaginary straight line. A few
centimeters/inches could already be enough to improve the sound and
picture quality. If the reception is perfect, no adjustments are necessary.
5. Turn on the connected equipment and enjoy wireless reception.
Using the remote control feature:
The 2.4GHz system not only allows you to send audio/video from one area to another,
it also gives you the ability to control the source using your existing remote control
device. It converts the infrared (IR) signal emitted by your remote control to a radio
frequency (RF) signal in UHF band at the receiver and sends it back to the transmitter
where the RF signal is converted back to the original IR signal and beamed to the
audio/video source.
Use the IR cable and connect the 2.5mm plug to the input jack on the back of the
transmitter (IR-R). Place the IR sensor on the front of the display from the equipment
that need to be controled. It’s important to place the IR sensor as close as possible to
the IR sensor, which is behind the display, of the equipment.
