508598
3
Zoom out
Zoom in
Previous page
1/57
Next page
3
Product and user description:
1. Test button / battery indicator
Testing the smoke alarm
Like any other electronic device, smoke alarms are not foolproof. Smoke alarms contain electronic
components that can fail or wear out at any time.
We recommended that you test the smoke alarm every week to make sure it is working properly.
Push and hold the test button until the alarm sounds for a few seconds. If it does not sound, check if the
battery indicator flashes once every 45 seconds. If this is not the case, replace the battery immediately.
Battery indicator.
The battery indicator flashes every 45 seconds to show the smoke alarm is working properly. When the
battery indicator flashes and gives a short beep sound, it is indicating that the battery has low capacity and
should be replaced immediately.
2. Mounting plate
3. Mounting holes
Use the supplied screws and plugs to mount the
mounting plate to the ceiling.
4. Remove the mounting plate
Turn the mounting plate of the smoke alarm counter-
clockwise to get access to the battery compartment of
the smoke alarm.
5. Battery compartment
6. Safety catch
The safety catch prevents the smoke alarm being
returned to the mounting plate without inserting the
battery first.
7. Battery connector
Take off the plastic seal of the battery and connect
the battery with the battery connector. After placing
the battery test the alarm with the test button to ensure it is working properly (see testing the smoke alarm).
When the mounting plate is mounted and the smoke alarm tested after inserting the battery, place the
smoke alarm on the mounting plate by turning it clockwise.
1
3
3
2
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-SA100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-SA100 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info