508751

Konig Electronic SEC-PCC30 Manual

27
Zoom out
Zoom in
Previous page
1/62
Next page
26
Name Description
1 Sensor ID Select Sensor ID which to be configured. Click on the
“Apply to all” will allow the user to configure all the
sensors at same time.
2 Alarming Specify the name of current sensor. The name will show
up on the Event Log List, and also the message box of
Main Monitor Panel.
3 Corresponding
Camera
Select the camera to be related with current sensor.
4 Enable Sensor
Detection
Click here to enable sensor detection .Click on the
“Schedule” to setup the week schedule of sensor
detection.
5 Delay Time The alarm will be triggered only after the sensor detection
is triggered continuously for the seconds specified here.
Note: This design is to avoid miss-trigger of sensor
detection event.
6 NC/NO NC(Normal Close): indicate sensor is normally at 0
NO(Normal Open): indicate sensor is normally at 1
7 Play Sound Play sound when motion detect event is triggered.
8 Video Clip Enable video recording in Event List Table. Refer to
“Chapter 4 Event Log Panel”
9 Alarm Output When sensor detected, the system will then trigger the
specified Alarm Output here.
10 Notifying
Personnel
User can specify which person to notify via E-Mail or
Phone or Mobile Phone.
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-PCC30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-PCC30 in the language / languages: English as an attachment in your email.

The manual is 4,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info