626906
10
Zoom out
Zoom in
Previous page
1/103
Next page
1111
English
Troubleshooting
If you cannot solve the problem, contact your
dealer.
Problem Possible cause Solution
The display on the front panel does
not light up.
The mains plug is not inserted into the wall socket. Insert the mains plug into the wall socket.
No sound or image, but the front
panel shows a red light.
The receiver is in standby mode. Press the on/standby button.
No sound or image.
The satellite dish is not pointing to the satellite.
Adjust the satellite dish.
Check the signal level in the “Antenna Setup” menu.
There is no signal or only a weak signal.
Check the cable connections.
Make sure that the LNB and other equipment are connected
between the LNB and the receiver.
Adjust the satellite dish.
Bad image / Blocking error.
The satellite dish is not pointing to the satellite. Adjust the satellite dish.
The signal is too strong. Connect a signal attenuator to the LNB input.
The satellite dish is too small. Use a larger satellite dish.
The noise factor of the LNB is too high. Use an LNB with a lower noise factor.
The LNB is faulty. Replace the LNB.
The image is not shown when the
device is swicthed on.
The system is connected with RF cables.
Check the UHF channel in the system and tune the UHF
channel correctly.
The system is connected with RF cables and the output
channel of the receiver interferes with an existing terrestrial
channel or a video signal.
Change the output channel of the receiver to a more
suitable channel.
Connect the system with SCART cables.
The remote control does not work.
The battery is low. Replace the battery.
The remote control is not pointing to the device.
Point the remote control to the device.
Make sure that nothing blocks the front panel.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic DVB-S2 REC11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic DVB-S2 REC11 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 3,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info