780529
21
Zoom out
Zoom in
Previous page
1/45
Next page
KONA OWNER’S MANUAL
B. Seat Post Cam Action Clamp
Some bikes are equipped with a cam action seat post
binder. The seat post cam action binder works exactly like
the traditional wheel cam action fastener (Section 4.A.2)
While a cam action binder looks like a long bolt with a
lever on one end and a nut on the other, the binder uses
an over-center cam action to rmly clamp the seat post
(see g. 8a).
WARNING: Riding with an improperly tightened
seat post can allow the saddle to turn or move and
cause you to lose control and fall. Therefore:
1. Ask your dealer to help you make sure you know
how to correctly clamp your seat post.
2. Understand and apply the correct technique for
clamping your seat post.
3. Before you ride the bike, rst check that the seat
post is securely clamped.
Adjusting the seat post cam action mechanism
The action of the cam squeezes the seat collar around
the seat post to hold the seat post securely in place. The
amount of clamping force is controlled by the tension
adjusting nut. Turning the tension adjusting nut clock-
wise while keeping the cam lever from rotating increases
clamping force; turning it counterclockwise while keeping
the cam lever from rotating reduces clamping force. Less
than half a turn of the tension adjusting nut can make the
difference between safe and unsafe clamping force.
WARNING: The full force of the cam action is
needed to clamp the seat post securely. Holding the
nut with one hand and turning the lever like a wing nut
with the other hand until everything is as tight as you
can get it will not clamp the seat post safely.
WARNING: If you can fully close the cam lever
without wrapping your ngers around the seat post or
a frame tube for leverage, and the lever does not leave
a clear imprint in the palm of your hand, the tension is
insufcient. Open the lever; turn the tension adjusting
nut clockwise a quarter turn; then try again.
C) BRAKES
WARNING: 1. Riding with improperly adjusted
brakes, worn brake pads, or wheels on which the rim
wear mark is visible is dangerous and can result in
serious injury or death.
2. Applying brakes too hard or too suddenly can lock
up a wheel, which could cause you to lose control and
fall. Sudden or excessive application of the front brake
may pitch the rider over the handlebars, which may
result in serious injury or death.
3. Some bicycle brakes, such as disc brakes (g. 11)
and linear-pull brakes (g. 12), are extremely power-
ful. Take extra care in becoming familiar with these
brakes and exercise particular care when using them.
4. Some bicycle brakes are equipped with a brake force
modulator, a small, cylindrical device through which
the brake control cable runs and which is designed to
provide a more progressive application of braking force.
A modulator makes the initial brake lever force more
gentle, progressively increasing
force until full force is achieved. If
your bike is equipped with a brake
force modulator, take extra care in
becoming familiar with its per-
formance characteristics.
5. Disc brakes can get extremely
hot with extended use. Be careful
not to touch a disc brake until it
has had plenty of time to cool.
20
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kona 2012 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kona 2012 in the language / languages: English as an attachment in your email.

The manual is 2.75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info