625968
148
Zoom out
Zoom in
Previous page
1/226
Next page
TROUBLESHOOTING
146
3.7.5.1 REMOVING AND INSTALLING THE BATTERY
q Before removing the battery, disconnect the earth cable (-).
If a tool touches the positive terminal and the frame of the machine at the same time, sparks may be generated.
q When installing the battery, connect the earth cable (-) last.
q Install the battery correctly. During this operation, take care to prevent the clamps from touching the terminals.
q When changing the battery, secure it with the clamp (1) and
tighten the fastening screw (2) with the required torque.
q Make sure that the cover is correctly positioned. If the cover is
damaged, change it immediately.
q If the battery terminals are oxidized, clean them carefully using
a metal brush.
3.7.5.2 CHARGING THE BATTERY
When charging the battery, always follow the instructions given in
paragraph "3.7.5 IF THE BATTERY IS DOWN" and in the user's
manual of the battery charger, and proceed as indicated below.
q During recharge the battery produces hydrogen, which is
flammable and may explode, therefore for this operation it is
necessary to remove the battery from the machine, position it in
a well ventilated place and remove the caps before proceeding.
q Immediately change any damaged caps.
q Set the voltage of the battery charger so that it corresponds to
the voltage of the battery to be charged. If the voltage is not set
correctly, the battery charger may overheat and cause an
explosion.
q Connect the positive clamp (+) of the battery charger to the positive terminal (+) of the battery, then connect the
negative clamp (-) of the battery charger to the negative terminal (-) of the battery.
q Set the recharge current to 1/10 of the rated capacity of the battery; when carrying out a quick recharge, set it to
a lower value than the rated capacity of the battery.
If the recharge current is too high, there may be an electrolyte leakage or the electrolyte may dry up and the
battery may consequently catch fire and explode.
q If the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source. The
battery may catch fire and explode.
q Do not use or charge the battery if the electrolyte level is below the MIN. reference mark, since this may cause
an explosion. Check the electrolyte level periodically and top up with distilled water until reaching the MAX.
reference mark.
RYA02970
148


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Komatsu Galeo PC14R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Komatsu Galeo PC14R-2 in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info