20
- Always disconnect the external adaptor from the power source when charging is complete.
- Do not leave the pool vacuum in charge for over 20 hours.
- Immediately turn the power off and disconnect the external adaptor from the power source
if you detect any of the following conditions:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
-
1. Make sure that the pool vacuum is turned off prior to charging.
2. Connect the external adaptor to the power source. Once the pool vacuum begins
charging, the indicator light on the external adaptor will turn red. Normally, it takes about
4- 5 hours to reach a full charge. The indicator light will turn green when the pool vacuum
is almost fully charged.
NOTE: If the motor is generating noise, immediately turn off the device by pressing the
ON/OFF button. Otherwise, it could potentially lead to failure of the shaft seals / motor,
and the warranty will be voided as a result.
NOTE: Charge the pool vacuum completely (about 4-5 hours) prior to the first use.
3. When charging is complete, disconnect the external adaptor from the power source and
unplug the jack from the charging base.
4. Detach the charger base from the pool vacuum.
Normally, the pool vacuum can be operated up to 30 minutes on a full charge
(charged for 4-5 hours)
NOTE:Clean the filter regularly. Too much debris inside the filter will increase burden to the
motor operation and then shorten the operating duration.
FACT: Rechargeable lithium-Ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, running time of
the pool vacuum will gradually reduce through repeated charging and discharging in
operation.
NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.
