744214

Kogan KASWPSTM11A Manual

12
Zoom out
Zoom in
Previous page
1/22
Next page
12
1) Turn on the brush switch to activate the brush.
2) To empty the dust bin, turn the power off and pull the dust bin from the side of head.
Empty it into a trash can. The dust bin may be warm to touch.
3) Replace the dust bin by pushing it back into the head until it snaps back into place.
Steam cleaning floors
1) Select one of the following steam regulator positions:
1-Low, 2-Medium, 3-High and 4-Hot Spray.
• 1-Low and 2-Medium settings: Ideal for cleaning all hard floors, such as linoleum,
ceramic, marble, wood, etc.
• 3-High settings: Ideal for cleaning carpets and rugs.
• 4-High spray settings: Ideal for cleaning bathroom, kitchens, windowsills, car
wheels, etc.
You can change the steam regulator position and change the steam output while
operating the steam mop sweeper.
2) Once the unit has been fully assembled and filled with water, plug in the power cord to
a grounded electrical outlet. Steam switch (O/I) is in the OFF (O) position, turns the steam
switch (O/I) to the ON (I) position. Approximately after 8 seconds, the mop will start
emitting steam. Adjust the steam regulator according to your requirement. To stop
emitting steam, you need to turn off the steam switch. Make sure to turn the unit totally
OFF after each usage and disconnect from the electrical outlet so the unit is in the totally
OFF status when used next time.
3) Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt
loosened by the steam. Apply steam liberally. Keep a towel handy and wipe away any
excess water that may accumulate.
4) When the steam cleaner stops emitting steam, simply turn OFF and unplug the
appliance, refill the water tank and continue cleaning.
Never leave the steam cleaner unattended while plugged in. For best results:
1. Sweep or vacuum floor prior to using the mop.
2. To avoid pudding of water, the microfiber cloth must be clean and dry for use. To
replace the cleaning cloth, proceed as follows: Let the cleaning cloth cool down,
remove the cloth from unit, replace with a new microfiber cloth and continue use.
Select low steam regulator position.
3. To sanitise an area of your floor, leave the steam cleaner at high steam setting over
the steam area for about 10 seconds, but not more than 15 seconds.
Do not carry out this procedure on heat and steam sensitive floors.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kogan KASWPSTM11A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kogan KASWPSTM11A in the language / languages: English as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info