Manual Koga Pace B20 - 2022 (page 100 of 148) (English, German, Dutch, Danish, French)

799481

100

Zoom out

Zoom in

1/148

English – 4

0 275 007 XD2 | (25.04.2018) Bosch eBike Systems

Switching the push assistance on/off

The push assistance aids you when pushing your eBike. The

speed in this function depends on the selected gear and can

reach a maximum of 6 km/h. The lower the selected gear,

the lower the speed of the push assistance function (at full

power).

uThe push assistance function must only be used when

pushing the eBike. There is a risk of injury if the wheels

of the eBike are not in contact with the ground while using

the push assistance.

To activate the push assistance, briefly press the WALK

button on your on-board computer. After activation, press

the + button within 3s and keep it pressed. The eBike drive

is switched on.

Note: The push assistance cannot be activated at assistance

level OFF.

The push assistance is switched off as soon as one of the

following occurs:

– You release the + button;

– The wheels of the eBike are locked (e.g. by applying the

brakes or hitting an obstacle);

– The speed exceeds 6 km/h.

Note: On some systems, the push assistance can be started

directly by pressing the WALK button.

Note: A speed of 18 km/h (start assistance) can be reached

on some systems.

Depending on the statutory specifications in some countries,

the push assistance function may vary from region to region.

Back-pedalling function (optional)

On bikes with a back-pedalling function, the pedals rotate

when the push assistance is switched on. If the rotating ped-

als are locked, the push assistance switches off.

Switching bicycle lights on/off

On the model where the bike lights are powered by the eBike

system, the front light and taillight can be switched on and

off at the same time via the on-board computer.

Notes on cycling with the eBike

system

When does the eBike drive work?

The eBike drive assists your cycling only when you are ped-

alling. If you do not pedal, the assistance will not work. The

motor output always depends on the pedalling force you ap-

ply.

If you apply less force, you will receive less assistance than if

you apply a lot of force. This applies irrespective of the as-

sistance level.

The eBike drive automatically switches off at speeds over

25/45km/h. When the speed falls below 25/45km/h, the

drive automatically becomes available again.

An exception applies to the push assistance function, in

which the eBike can be pushed at low speed without ped-

alling. The pedals may rotate when the push assistance is in

use.

You can also use the eBike as a normal bicycle without as-

sistance at any time, either by switching off the eBike system

or by setting the assistance level to OFF. The same applies

when the battery is drained.

Interaction between the eBike system and gear-

shifting

The gear-shifting should be used with an eBike drive in the

same way as with a normal bicycle (observe the operating in-

structions of your eBike on this point).

Irrespective of the type of gear-shifting, it is advisable to

briefly stop pedalling when changing gear. This will facilitate

the gear change and reduce wear on the powertrain.

By selecting the correct gear, you can increase your speed

and range while applying the same amount of force.

Gaining initial experience

We recommend that you gain initial experience with the

eBike away from busy roads.

Test the various assistance levels, beginning with the lowest

level. As soon as you feel confident, you can ride your eBike

in traffic like any other bicycle.

Test the range of your eBike in different conditions before

planning longer and more demanding trips.

Influences on range

The range is affected by a number of factors, such as:

– Assistance level

– Speed

– Gear shifting behaviour

– Tyre type and tyre pressure

– Age and condition of the battery

– Route profile (gradients) and conditions (road surface)

– Headwind and ambient temperature

– Weight of eBike, rider and luggage

For this reason, it is not possible to predict the range accur-

ately before and during a trip. However, as a general rule:

– With the same assistance level on the eBike drive: The

less energy you need to exert in order to reach a certain

speed (e.g. by changing gears optimally), the less energy

the eBike drive will consume and the higher the range per

battery charge will be.

– The higher the selected assistance level under otherwise

constant conditions, the smaller the range will be.

Taking care of your eBike

Please observe the operating and storage temperatures of

the eBike components. Protect the drive unit, on-board com-

puter and battery against extreme temperatures (e.g. from

intense sunlight without adequate ventilation). Extreme tem-

peratures can cause the components (especially the battery)

to become damaged.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Koga Pace B20 - 2022 in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 13.08 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Koga Pace B20 - 2022 Manual

Product: