782789
23
Zoom out
Zoom in
Previous page
1/34
Next page
23
English
Content
1 x Dishwasher
1 x User manual
1 x Warranty card
Part list
AControl panel
A1 On/o switch
A2 Program selection button P
A3 3in1 function button
A4 Rinse zone selection button
A5 Timer button
A6 Digital display
A7 Rinse aid indicator
A8 Softener (salt) indicator
A9 Water connection indicator
A10 Program display
A11 Rinse zone indicators
BHandle
CDoor
DCutlery tray
EUpper dish basket
FLower dish basket
GFill compartment
Detergent tab/powder compartment
G1 Cover
G2 Compartment for main washing
G3 Lock
G4 Compartment for pre-washing
Rinse aid compartment
G5 Fill indicator
G6 Rinse aid container
HInside
H1 Salt container
H2 Water outlet with filter set
H3 Upper and lower spray arms
Backside
IPower cord with plug
JWaste water hose (pre-assembled)
KHose for water inlet (pre-assembled)
Accessories
Funnel (not shown)
Installation
Fig. 1The dishwasher must be installed in
sucient proximity of water, sewage
and electrical connection.
Caution
After unpacking open the door and remove
all transport protections from the baskets
and spray arms. Ensure that the spray arms
can rotate freely.
Note:
Please check the included mounting material,
brackets, screws and Velcro strip for attaching
the decorative panel, etc.
1Observe the installation dimensions.
• A location near the sink is recommended
to allow for an easier connection of
the dishwasher to water and sewage
connections
• At the back of one or both lateral
cupboards, recesses of size 80 x 100 mm
must be fitted for water, sewage and
electrical connection (A).
If the dishwasher is installed in a corner, a
minimum clearance of 50 mm between the
opened door and surrounding cabinets must
be respected.
Note the dimensions, holes and cutouts of
the decorative plate.
2Fasten the condensation strip below the
worktop. Make sure that it closes with the
front edge of the countertop.
3Make sure that the power cord and the
water inlet and outlet are not under tension
and that they are not bent. Make sure that
the water connection is correct to prevent
leakage.
4Lay the drain hose without pulling and
kinking. Do not force the dishwasher under
the worktop, but only by hand.
5Place the dishwasher in its final position.
The dishwasher must be placed in a
absolutely level installation position.
• The rear stands can be adjusted in height
by turning the middle Phillips screw
(Pos.A). Please refer to the figure next to
the screw (UP: rear is raised, DOWN: rear
is lowered).
• The front feet can be adjusted by turning
them by hand.
• Check the horizontal stand with a spirit
level on horizontal or vertical surfaces in
the interior of the dishwasher and the
door.
6Make sure that the dishwasher is placed
level and does not tilt.
7Mark the holes for the retaining plates and
sleeves on the decorative plate and pre-drill.
8Fix the sleeves at the top and the retaining
plates at the bottom of the decor panel.
9Now hang the decor panel on the matching
recesses on the door and attach it to the
door of the dishwasher.
10 Remove the 4 screws. Screw the supplied
4 long screws through the door and fasten
the decorative plate.
11 The springs of the dishwasher door were
set correctly at the factory.
• After installation of the decorative plate,
the spring force of the door may have to
be adjusted.
• Twist the adjusting screws on both sides
to increase/decrease the spring force.
Please refer to the illustration next to
the screws.
• The spring force is adjusted correctly
when the fully opened door remains in a
horizontal position and can be moved up
all the way by slightly pulling on it.
IM_KDW 60031 A2 FI_180326_V05_HR.indb 23 26/3/18 12:08 pm
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Koenic KDW 60031 A2 FI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Koenic KDW 60031 A2 FI in the language / languages: English, German as an attachment in your email.

The manual is 22.52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info