212625
37
Zoom out
Zoom in
Previous page
1/47
Next page
A-61560 January 2010 5-1
5 Troubleshooting
Contents Problem solving ..............................................................................5-1
LED error codes.............................................................................. 5-3
Contacting Service..........................................................................5-4
Problem solving Occasionally you may encounter a situation with your scanner where it
may not function properly. Use the chart below as a guide to check
possible solutions to help you resolve the situation before calling
Technical Support.
Problem Possible Solution
Documents are jamming or multiple
documents are feeding
Make sure that:
the side guides are adjusted for the width of the documents you are
scanning.
the output tray is adjusted for the length of the documents you are
scanning.
all documents meet the specifications for size, weight and type as
outlined in Appendix A, Specifications.
the scanner and tires are clean.
the spring on the pre-separation module is adjusted to the proper
tension. See the procedures in Chapter 4, Maintenance.
the feed module and pre-separation module is installed properly and
securely in place. See the procedures in Chapter 4, Maintenance.
To remove a document jam:
IMPORTANT: Be sure the input tray is up before opening the cover. Do
not pull the jammed document out of the scanner; open
the scanner cover first.
Open the scanner cover.
Remove any jammed document(s) from inside the scanner.
Close the scanner cover and resume scanning.
Scanner will not scan/feed documents
Make sure that:
the power cord is plugged securely into the back of scanner and the
wall outlet.
the power supply, green LED is lit.
the power switch is on.
the wall outlet is not defective (call a licensed electrician).
the PC was restarted after installing the software.
document(s) is making contact with the feed rollers.
If you are feeding a stack of documents (more than 40) in the upright
position, and the transport will not start, it may be necessary to shingle
the bottom documents so the feed rollers can grasp the first document
and start the feeding process, or use the tilt button to rotate the scanner
in the downward position.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kodak i1310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kodak i1310 in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info