Manual Klipsch XF-48 (page 4 of 36) (English, German, French, Italian, Spanish)

582121

Zoom out

Zoom in

1/36

Care and Cleaning

• Occasional dusting or wiping of the cabinet with a cloth

is all that is required. Never use abrasive or solvent type

cleaners or harsh detergents.

• A vacuum cleaner with a soft brush attachment may be used

to clean the grille fabric.

• Never spray polishes or cleaners on the drive units (woofers,

midranges or tweeters).

FCC and Canada Compliance Information

NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protec-

tion against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Approved under the veriﬁcation provision of FCC Part 15 as a Class

B Digital Device.

Caution: Changes or modiﬁcations not expressly approved by the

manufacturer could void the user’s authority to operate this device.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme á la norme

NMB-003 du Canada

EU Compliance Information

Eligible to bear the CE mark, Conforms to European Union Low Volt-

age Directive 73/23/EEC and 2006/95/EC; Conforms to European

Union EMC Directives 89/336/EEC and 2004/108/EC.

WEEE Notice

Note: This mark applies only to countries within the European Union

(EU) and Norway.

This application is labeled in accordance with

European Directive 2002/96/EC concerning waste

electrical and electronic equipment (WEEE). This label

indicates that this product should not be disposed of

with household waste. It should be deposited at an

appropriate facility to enable recovery and recycling.

Power - This switch allows you to select either “AUTO” or “ON”

for the speakers built in ampliﬁer. When “AUTO” is selected, the

speaker will automatically turn on when it senses a signal. It will

automatically turn off after 20 minutes if no signal is present. In the

“ON” setting the speaker will remain on as long as the AC power

cord is plugged into a wall socket. The power indicator LED on the

front panel will illuminate BLUE when speaker is on and RED when

the speaker is in standby. The LED will be off if the AC power cord

is not connected to an AC outlet.

Input Sensitivity - This switch adjusts the level of the input signal

to optimize the performance of the built-in ampliﬁer. See “Active

Floorstanding Connections” for more information.

Active Floorstander Controls

(See ﬁgure 5.)(XF-48 only)

Bass Management

When using your speakers in a home theater system, consult

the owner’s manual of your surround electronics for proper

application of bass management settings.

• As a general rule, compact speakers (Bookshelf, Center

Channel and Surrounds) are set to the “Small,” or bass-

limited setting.

• Floorstanding speakers are typically set to the “Large,” or

full-range setting.

• Also refer to the electronics instructions for adjusting the

relative volume levels of the speakers so they are at the same

level when in the listening position.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch XF-48 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 6,99 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Klipsch XF-48 Manual

Product: