Manual Klipsch KL-650-THX (page 3 of 7) (English)

582116

Zoom out

Zoom in

1/7

Surround Back Loudspeakers

In addition to the left and right surrounds, THX Ultra2 7.1-channel system specifications call

for two forward-radiating surround back loudspeakers behind the listening area, preferably

spaced no more than a few feet apart. These would be KL-650-THX or KL-525-THX LCR’s,

either placed on stands, or ideally mounted on the back wall. Like the left and right

surrounds, they should be slightly above seated ear level – about five to six feet off of the

floor. In some installations, it may be preferable to use KS-525-THX’s for the surround back

channels due to their smaller size. Their WDST design works very well in this application.

You will probably want to space the KS-525-THX surround back pair somewhat farther

apart than you would the LCR’s.

Subwoofers

Two KW-120-THX subwoofers and a KA-1000-THX amplifier are required to meet THX

Ultra2 maximum output requirements. This specification assumes a very large room,

however, and in many installations a single KW-120-THX will be completely adequate.

Although the KW-120-THX will perform well in a wide variety of locations, you will get the

most out of it by following some simple guidelines:

• Although the subwoofer’s orientation is not at all critical, avoid placing the front (driver)

side of the cabinet up against a wall.

• The subwoofer’s output will increase as it is moved closer to walls, with maximum output

when it is placed in a corner. If practical, always place the subwoofer against or near a

wall.

• In most rooms, a subwoofer will deliver smoothest bass response when placed in a

corner away from room openings, such as doors. So if possible, that’s the place to start.

• If you are using more than one subwoofer, you usually will get best performance by

placing them together in the same location rather than by spacing them apart.

Naturally, there are exceptions to the general rules, since no two rooms or systems are

exactly alike. Once you have the subwoofer connected to your system and adjusted at

least roughly (see the KA-1000-THX manual for details), you may want to experiment to

see if you can do better.

C O N N E C T I O N S

Note: Proper connection of your speakers to your amplifier or receiver is vital to obtaining

good soun

d quality. Please follow these directions carefully. Sloppy connections can cause

amplifier malfunctio

n or damage.

Klipsch THX Ultra2 loudspeakers are internally wired with custom Monster Cable® Z-Series

speaker wire. Its Frequency Specific™ design employs multiple gauges of high-purity cop-

per wire, carefully selected and wound to ensure optimum signal transfer at all frequencies.

You will obtain best performance from your speakers if you connect them to your amplifier

or receiver with Monster Cable or similar high quality wire available from your dealer. (The

KW-120-THX comes with a 20-foot length of Monster THX Ultra-certified 1000 Series

speaker cable terminated in professional-grade Neutrik

NL2 Speakon

connectors that

mate with the jacks on the subwoofer and the companion KA-1000-THX amplifier.) At mini-

mum, we recommend that you use 16-gauge or heavier stranded copper wire. Use lower-

gauge (heavier) wire for long runs to maintain correct frequency response and minimize

power loss.

On the back of each KL-650-THX, KL-525-THX and KS-525-THX speaker are two sets of

binding posts, one feeding the tweeter and the other the woofers. For conventional wiring,

these sets are connected together with gold-plated metal straps, which can be removed for

bi-wiring or biamping. We will explain ordinary single-wiring first and then the alternatives.

All the information regarding single-wiring also applies to bi-wiring.

BUT FIRST: TYPES OF CONNECTO R S

Bare wire.

Pull the two conductors apart for about an inch and strip approximately 1/4-inch

of insulation from the end of each. (A wire stripper will simplify this, but you can use an

ordinary pocket knife to cut around and through the insulation down to the wire.) Twist the

strands of wire on each individual conductor tightly together. Loosen the nuts on a pair of

binding posts until the holes through the metal posts are exposed, then insert the bare wire

through the holes. Screw the nuts down finger-tight on the wire. Make sure that no strands

of wire are touching from one binding post to the other or to any strands from the other

conductor. Failure to observe this precaution at either end of the connection can result in

amplifier malfunction or damage.

Pins.

Many pre-made speaker cables are terminated with metal pins. Loosen the nuts on a

pair of binding posts until the holes through the metal posts are exposed, then insert the

pins through the holes. Screw the nuts down finger-tight on the pins — do not overtighten.

KW-120-THX will be completely adequate. The companion KA-1000-THX subwoofer amplifier

can drive either one or two subwoofers. In dual-subwoofer systems, it is usually best to place

them right next to each other rather than spaced apart.

Front LCR Loudspeakers

Normally the array would be either all KL-650-THXs or all KL-525-THXs, but the center

speaker can be different from the left and right speakers. (For example, you might combine a

pair of KL-650-THXs for the front left and right with a KL-525-THX for the center.) The cen-

ter-channel speaker should be centered along the width of the TV screen, directly above or

below it or, in the case of an acoustically transparent front-projection screen, behind it. The

left and right speakers should be placed equal distances out from the edges of the TV screen.

Exactly how far out depends on the size of the screen. A reasonable starting point is to place

the left and right speakers so that they and your listening position form an equilateral triangle.

Since the center speaker helps anchor the sound to the screen, it usually is better to have the

left and right speakers spread a little too wide than to have them too close together. The left

and right speakers should be aimed inward towards the listening position as shown in figure

2. In some installations, it may be desirable to wall-mount the front LCR speakers rather than

to put them on stands or in a cabinet. To accommodate this, the KL-650-THX and KL-525-

THX are both configured for use with OmniMount

60.0 Series wall-and ceiling-mount brack-

ets (See Figure 3). Refer to the OmniMount manual for detailed installation instructions.

Surround Left and Right Loudspeakers

In a 5.1- or 7.1-channel installation the left and right surround speakers will be KS-525-

THX’s placed to the sides of the listening area, typically on or against the walls. They should

be elevated slightly above seated ear level – five or six feet above the floor is a good target. If

desired, the speakers can be moved back along the wall to as much as 20 degrees behind

the listening position, especially in a 5.1-channel system. The KS-525-THX’s Wide Dispersion

Surround Technology design gives you a great deal more latitude if you need it, delivering

good results in configurations that depart significantly from the ideal. The KS-525-THX has a

keyhole mount for use in hanging the speaker on the wall. To use the keyhole, all you need is

a screw or nail of the appropriate size protruding slightly from the wall. If possible, the nail or

screw should be driven into a wall stud; if not, be sure to use appropriate anchors in the dry-

wall or plaster. Additionally, the KS-525-THX is configured for use with OmniMount

20.0

Series wall-and ceiling-mount brackets (See Figure 3). Refer to the OmniMount manual for

detailed installation instructions.

Figure 2

Figure 3

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch KL-650-THX in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Klipsch KL-650-THX Manual

Product: