584729

Klipsch Icon Series W Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
Connecting
• Your loudspeakers are equipped with positive (Red) and negative
(Black) connection terminals on the rear of the cabinet. These
correspond to the positive and negative terminals on the
appropriate channel (left, right, center, rear etc.) of your amplifier.
3
Center Channel Speaker (See Figures 2A and 2B.)
• Place immediately above or below the center of your video display.
Surround Channel Speakers (See Figures 2A, 2B and 3.)
• Place above seated ear height on side or rear walls
(approximately 4-5 feet above the floor).
• Use the attached wall brackets to hook to appropriately sized
screw heads screwed into a wall stud and wall anchor or two
wall anchors with a suitable weight bearing capacity. (See
Figure 3.)
Never use the wall bracket for mounting the speaker to
the ceiling.
On Wall Placement
• Klipsch Icon bookshelf models may be wall-mounted using
the
1
/
4
-20 threaded insert on the rear of the speaker. Be sure
the mounting hardware you are using has the necessary load
bearing capabilities before hanging any speaker. If you use
a bracket, see the bracket owner’s manual for mounting details.
Turn your amplifier off before making any
connections.
Standard Connections (See Figure 4.)(All Models)
• All speakers in your system must be connected in phase with
the positive speaker terminal connected to the positive
amplifier terminal. Repeat this for the negative speaker
terminal and amplifier terminals. Most speaker wire has
distinguishing markings on the insulation of one of the
conductors to assist in correct hookup.
• Use 16 gauge (AWG), two conductor, copper wire at a
minimum and larger gauge wire for longer runs. The
connection terminals on your loudspeaker will accommodate
bare wire, spade terminals, and banana plugs.
With all connection types, take care that there is no
contact between the positive and negative terminals
at the speaker and amplifier. Damage to your equipment
may result.
WF-35 and WF-34 Standard Connections
• Use either pair of positive and negative terminals keeping the
metal coupling straps in place.
Bi-Wire Connections (See Figure 5.)
• The WF-35 and WF-34 are equipped with two pair of
connection terminals for bi-wire hookup and enhanced
performance.
• Remove the metal coupling straps.
• Connect one speaker wire (+ and -)to the top pair of binding
posts and a second speaker wire (+ and -) to the bottom pair
of binding posts.
Care and Cleaning
• Occasional dusting or wiping of the cabinet with a cloth
is all that is required. Never use abrasive or solvent type
cleaners or harsh detergents.
• A vacuum cleaner with a soft brush attachment may be used
to clean the grille fabric.
• Never spray polishes or cleaners on the drive units (woofers,
midranges or tweeters).
Bass Management
When using your speakers in a home theater system, consult
the owner’s manual of your surround electronics for proper
application of bass management settings.
• As a general rule, compact speakers (Bookshelf, Center
Channel and Surrounds) are set to the “Small,” or bass-
limited setting.
• Floorstanding speakers are typically set to the “Large,” or
full-range setting.
• Also refer to the electronics instructions for adjusting the
relative volume levels of the speakers so they are at the same
level when listened to from the primary listening position.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Klipsch Icon Series W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch Icon Series W in the language / languages: English as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info