Manual Klarstein 10033109 Antarctica (page 17 of 64) (English, German, French, Italian, Spanish)

753563

Zoom out

Zoom in

1/64

INSTALLATION

• After unpacking, carefully check the machine for damage during transport, then

remove the accessory, wipe the ice bucket with a clean damp cloth.

• This series of machines should be placed in the air circulation of clean places, not

open to the ground, should not be exposed to direct sunlight and rain, can not be

placed near the heat source.

• The ambient temperature of this series of machines should be no less than 3°C, not

higher than 40°C, around the appropriate spacing should be retained to maximize

the efciency of ice and machine cooling.

Part Distance (cm)

Side 15

Back 20

Front 50

• ● When installing the ice machine, please check the front and rear directions level.

• ● This series of machines is strictly prohibited to place the ice below the freezing

point of ice, otherwise it will produce serious failure.

Installation of Power

• The power supply should be the same as that on the machine nameplate

(220 V / 50 Hz or 380 V / 50 Hz).

• The power plug should be plugged directly into a power outlet with a ground wire

and not on a temporary terminal block. All lines must meet national or regional

standards.

• The voltage uctuation must not exceed ± 10% of the rated voltage, otherwise the

regulator should be installed.

• The grounding of this series must meet the electrical standard.

The Antarctica ice maker is making a few chucks fo ice and then the maker fills with just water....please advise
Submitted on 6-7-2022 at 12:52
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Klarstein 10033109 Antarctica in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Klarstein 10033109 Antarctica Manual

Product: