Manual Klarfit 10030508 Pacemaker X3 (page 18 of 28) (English, German, French)

777919

Zoom out

Zoom in

1/28

Maintenance, Storage

Cleaning

Make sure that the treadmill and the area around and under it is clean. It is especially important that

the running belt, the side rails and also the oor under the belt are kept clean, so no dirt gets between

the running belt and the sliding surface or under the motor cover. Dirt and dust can quickly result in

Increased wear, as well as damaging the machine. Vacuum the running belt and the sides of the belt as

needed or at least once a week, the rest can be wiped with a slightly damp cloth (a mild soap solution

is ok). To avoid getting water in electrical components, the treadmill should not be cleaned with a wet

cloth, swab or mop.

Lubricating with silicone oil:

The treadmill comes lubricated when purchased. It should then be lubricated about every 30th time it is

used (or once every other month), Turn o the power, lift up the rubber mat on the right side with one

hand and spray silicone oil moderately along the whole sliding surface under the mat. Do the same on

the left side. Turn on the belt at its lowest speed and walk for roughly three minutes so the silicone oil is

evenly spread out.

Adjusting the running belt

Check that the belt is centered. If it is not, adjust the belt so that it runs freely (see below). Check that

the running belt is correctly centered between the back tail covers every time before using the treadmill.

Adjust the belt if needed, normally only a small adjustment is required. Screw half a turn clockwise on

the side that the belt is too near to, then test for at least 15 seconds at 4km/h (check and adjust a further

quarter or half turn until the belt is centered).

NOTE: the running belt should not be tightened too hard as this can cause noise and damage the ma-

chine.

Storage: Remember to store the treadmill in a dry place and not to pile things on top of it.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Klarfit 10030508 Pacemaker X3 in the language / languages: English, German, French as an attachment in your email.

The manual is 2.96 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Klarfit 10030508 Pacemaker X3 Manual

Product: