784424
60
Zoom out
Zoom in
Previous page
1/68
Next page
60
Installation
8.6 Electrical connection
Only connect the appliance to the po-
wer supply once it is properly installed.
If the appliance is not tted with a con-
nector plug, a two-pole switch, confor-
ming to standards with a minimum open
contact gap of 3 mm is to be installed by
an authorized tradesman in an easily ac-
cessible location.
When the hood is connected to the
mains, all control lamps light up briey
and the hood switches to standby mode
(accompanied by a beep signal).
Never install the appliance if the data
on the rating plate (V) does not agree
with your supply voltage.
You will nd the rating plate inside the
appliance, behind the grease lter.
If the extractor hood is tted with a
standard connector plug, connect this
to an easily accessible standard socket.
!
8.3 Using the extractor hood as
an exhaust air hood (with air
extracted to outdoors)
If the extractor hood has been tted at
the factory with a carbon lter, this must
be removed for exhaust air operation.
It is only practicable to use this when
operating your hood in circulation
mode
.
8.4 Converting the extractor
hood to a circulation hood
If you wish to use the hood as a circulati-
on hood, you must mount the activated
carbon lter(s) to the fan motor before
using the hood. If not included in the
scope of supply, you must obtain the
carbon lter(s) from the supplier of your
extractor hood.
8.5
Mounting the carbon lter
Remove the metal grease lter.
The carbon lter is mounted in two
parts to the right and le of the motor.
Check whether the teeth correspond
to the direction of the rotation of the
respective side.
Turn the activated carbon lter onto
the motor housing (usually clockwise).
Reinsert the metal lter.
!
!
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KKT Kolbe SOLO906S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KKT Kolbe SOLO906S in the language / languages: English, German as an attachment in your email.

The manual is 1.32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info