784332
61
Zoom out
Zoom in
Previous page
1/68
Next page
61
EN
Mounting the hood
9. Mounting the hood
Edges and internal components can be
sharp-edged and cause injuries.
Exercise appropriate caution and pro-
tect yourself if necessary, e.g. with work
gloves.
For installation on solid masonry,
proceed as described below.
If the appliance is to be mounted on a
dierent type of wall (e.g. plasterboard,
aerated concrete, Poroton brick), replace
the mounting material according to the
substrate.
If the mounting surface is made of wood,
you can do without the dowels.
However ensure a secure hold.
Determine the desired position for
mounting the hood body support
bracket centrally above your hob
according to the previously mentioned
distance regulations and dimensions.
Note: The hood will later be suspen-
ded from the bracket on the rear up-
per edge. To be sure, you can also x it
beforehand and pre-align it optically.
Place the hood body support bracket
horizontally at the desired position
on the wall using a spirit level and
mark the position of the screw holes.
Drill a hole at each of the marked
positions according to the diameter
of the dowels.
Then carefully tap a dowel into each
of the holes with a hammer and fasten
the bracket to them with the screws
provided (4.2 × 30 mm).
boreholes
screws
dowels
support
bracket
Raise the hood body and attach it to
the wall bracket.
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KKT Kolbe SOLO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KKT Kolbe SOLO in the language / languages: English, German as an attachment in your email.

The manual is 1.32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info