784423

KKT Kolbe PLUTO9109S Manual

59
Zoom out
Zoom in
Previous page
1/68
Next page
59
EN
Installation
8.2 Important informations
before installing:
• The appliance must be disconnected
from the power supply during all
installation / assembly work.
• Clean the environment thoroughly
before and aer installation so that
no dust or construction debris can be
sucked in during initial operation.
• Only install the unit in a suitable
location.
• Check the wall for load-bearing capa-
city.
• Check the routing of electrical and
other cables on and in the wall or cei-
ling so that they are not drilled into.
• Check the condition and load-bearing
capacity of the electrical cables.
The installation of the appliance by a
specialist is recommended.
When installing the cooker hood, strictly
observe the minimum distances bet-
ween the hotplate and the cooker hood
(see „Installation data“) and follow the
description of the steps under „Ins-
talling the cooker hood“ and all other
instructions.
The manufacturer is not responsible for
malfunctions, damage or injury resulting
from non-compliance with the installati-
on instructions, regulations and notes.
In the execution with air exhausted
outdoors, the vapours are extracted via
an air exhaust hose xed to the connec-
tor ring.
An air outlet to the outside must be
provided for this purpose.
• The inner diameter of the exhaust air
hose must be 150mm and conform to
that of the connector ring.
• The exhaust air hose must not be led
through a sha together with gas
pipes, hot air pipes etc.
• Route the exhaust hose as straight as
possible away from the hood.
The maximum permissible bend to the
outside is 120°.
Note on backow aps
To prevent air leakage during exhaust air
operation (i.e. backow of outside air),
backow aps are pre-mounted on the
hood body.
Aer installing the exhaust air hose,
make sure that they can open and close
freely.
For recirculation operation or if there is
already a backow device in the exhaust
air system of your kitchen, these should
be removed.
!
… 59 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KKT Kolbe PLUTO9109S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KKT Kolbe PLUTO9109S in the language / languages: English, German as an attachment in your email.

The manual is 1.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info