784316
59
Zoom out
Zoom in
Previous page
1/64
Next page
59
EN
Mounting the hood
To prevent air leakage in exhaust air
mode (i.e. backow of outside air),
install the supplied backow aps on
the top of the bonnet in the air outlet.
Note: This step is not necessary for re-
circulation mode or if there is already
a backow ap in the exhaust air duct
of your kitchen.
Assemble the telescopic exhaust sha
from the two sha elements by sliding
them into each other and place it on
the hood body.
Pull the inner sharf part upwards
to the desired height and mark the
position of the upper corners adjacent
to the wall for both sha elements
on the wall.
From the inside of the cooker hood,
mark the positions of the holes in its
back on the wall.
(For this step, open the front ap
of the hood and remove the metal
grease lter).
Take the hood down, drill holes
at the marked points according to the
diameter of the dowels and carefully
tap one of the other dowels into each
of the drill holes with a hammer.
Hang the hood back in place and x
its rear side to the wall or dowels with
the additional screws (4.2 × 30 mm)
supplied.
59


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KKT Kolbe ECCO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KKT Kolbe ECCO in the language / languages: English, German as an attachment in your email.

The manual is 1.25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info