784314

KKT Kolbe DRAFT600 Manual

56
Zoom out
Zoom in
Previous page
1/64
Next page
56
Installation
8.2 Important information befo-
re installing the appliance:
• Clean the environment thoroughly
before and aer installation so that
no dust or construction debris can be
sucked in during initial operation.
• Check the condition and load-bearing
capacity of the electrical cables.
The installation of the appliance by a
specialist is recommended.
Follow the description of the work steps
in the mounting chapter and all further
instructions.
In the execution with air exhausted out-
doors, the vapours are extracted via an
air exhaust hose xed to the connector
ring.
• The diameter of the exhaust air hose
must conform to that of the connector
ring.
• The exhaust air hose must not be led
through a sha together with gas
pipes, hot air pipes etc.
• Route the exhaust hose as straight as
possible away from the hood.
The maximum permissible bend to the
outside is 120°.
• If a smoke non-return valve is used or
is planned, check whether it can open
and close freely aer the installation of
the exhaust air hose.
8.3 Using the extractor hood as
an exhaust air hood (with air
extracted to outdoors)
If the extractor hood has been tted at
the factory with a carbon lter, this must
be removed for exhaust air operation.
It is only practicable to use this when
operating your hood in circulation
mode
.
8.4 Converting the extractor
hood to a circulation hood
If you wish to use the hood as a circulati-
on hood, you must mount the activated
carbon lter(s) to the fan motor before
using the hood. If not included in the
scope of supply, you must obtain the
carbon lter(s) from the supplier of your
extractor hood.
8.5
Mounting the carbon lter
• Disconnect the appliance from the
power supply.
• Loosen the screws of the motor unit
and remove it.
• Screw the activated carbon lters
onto the motor housing (usually
clockwise).
… 56 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KKT Kolbe DRAFT600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KKT Kolbe DRAFT600 in the language / languages: English, German as an attachment in your email.

The manual is 1.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info