11
1. The appliance doesn't work.
• Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the main power switch on?
• Has the fuse blown?
• Is the power supply cable damaged?
• Is button (B) set to Stand-by?
2. The temperature inside the compartments is not low enough.
• Are the doors closed properly?
• Is the appliance installed near a heat source?
• Are the air circulation vents obstructed?
3. There is water on the bottom of the refrigerator compartment.
• Is the defrost water drain blocked?
4. The inside light doesn't work.
Check point 1, then:
• Disconnect the appliance from the power supply.
• If your product has a lamp, to check and replace it see the instructions and figure on the attached
sheet
• If your appliance has LED lights, contact the after-sales service.
5. Excessive frost build-up in the low temperature compartment.
• Is the low temperature compartment door closed properly?
6. The acoustic alarm sounds and the red led (G) flashes
• The door has been open for more than 2 minutes. Press button (F) to mute the alarm or close the
door.
7. The acoustic alarm sounds, the red led (G) and the letter "A" flash on the display
• Temperature sensor fault. Press button (F) to deactivate the alarm and contact the after-sales service
Notes:
• If the alarm condition described at point 7 arises, the temperature setting button (C) and button (D)
cannot be used, but the appliance still maintains compartment temperatures that guarantee safe storage
conditions for food
• It is normal for the appliance to make a range of noises (gurgling and hissing due to expansion in the
refrigerant circuit ...) during the normal operating cycle.
Troubleshooting guide
