7
Using for the first time
Connect the appliance to the power supply.
In models with electronics, a sound signal may be emitted, which means that the temperature alarm has
been activated: press the sound alarm off button. Where provided, position the antibacterial anti-odour
filter in the fan as demonstrated in the filter packaging.
Note: After turning the appliance on, you must wait for 4-5 hours for the correct storage temperature to be
reached for a normally filled appliance.
Clean the appliance occasionally with a cloth and a solution of warm
water and neutral cleaning agents specifically for cleaning the inside
of the refrigerator. Do not use abrasive cleaning agents. To ensure the
constant and correct flow of the defrosting water, regularly clean the
inside of the drain situated in the back wall of the refrigerator
compartment near the fruit and vegetable drawer using the utensil
provided (see figure).
Before carrying out any maintenance or cleaning, take the plug out of
the socket or disconnect the appliance from the power supply.
Replacing the light bulb or LED (depending on the model)
Always disconnect the appliance from the power supply before replacing the light bulb. Then follow the
instructions based on the type of light bulb for your product.
Replace the light bulb with one with the same features, available from the Technical Assistance Service and
authorised sellers.
Light type 1)
To remove the light bulb, unscrew it in an anti-clockwise direction, as
shown in the figure. Wait 5 minutes before reconnecting the appliance.
- traditional light bulb (max 25W)
or
- LED light bulb (with the same features)
only available from the Technical Assistance Service
Light type 2)
If the product has LED lights, as
demonstrated in the figures below,
contact the Technical Assistance
Service if you need a replacement.
LEDs last longer than traditional
light bulbs, improve internal
visibility and are environmentally-
friendly.
Light bulb
LED light bulb
Maintenance and cleaning of the applicance
