11
Cleaning
• If the oven is installed below a hob, make sure
that all burners or electric hotplates are switched
off during the self-cleaning (pyrolysis) function.
• Remove all accessories before running the
pyrolysis function.
• For optimum cleaning of the oven door, remove
the worst soiling with a damp sponge before
using the pyrolytic function.
The appliance is equipped with 2 pyrolysis functions:
1. Energy-saving cycle (PYRO EXPRESS/ECO):
which consumes approximately 25% less energy
than the standard cycle. Select it at regular
intervals (after cooking meat on 2 or 3
consecutive occasions).
2. Standard cycle (PYRO): which is suitable for
cleaning a very dirty oven.
• In any case, after a certain number of uses and
depending on how dirty the oven is, a message
on the oven display advises you to run a self-
cleaning cycle.
N.B: during the pyrolysis function, the oven
door will not open; it will remain locked until
the temperature inside the oven has returned
to an acceptably safe level.
- Use safety gloves.
- Ensure the oven is cold before carrying out the following
operations.
- Disconnect the appliance from the mains power supply.
REMOVING THE DOOR
To remove the door:
1. Open the door fully.
2. Lift the catches and push them forwards as far as they will go (fig. 1).
3. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is
released (D) (fig. 2).
To refit the door:
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door.
WARNING
Maintenance
(fig. 1)
(fig. 2)
