10
Check that the voltage on the rating plate
corresponds to the voltage in the home.
Do not remove the microwave inlet protection
plates located on the side of the microwave oven
cavity wall. They prevent grease & food particles
from entering the microwave inlet channels.
Ensure the microwave oven cavity is empty before
mounting.
Ensure that the appliance is not damaged. Check
that the microwave oven door closes firmly against
the door support and that the internal door seal is
not damaged. Empty the microwave oven and
clean the interior with a soft, damp cloth.
Do not operate this appliance if it has a damaged
mains cord, if it is not working properly, or if it has
been damaged or dropped. Do not immerse the
mains cord in water. Keep the cord away from hot
surfaces.
Electrical shock, fire or other hazards may result.
If the power supply cord is too short, have a
qualified electrician or serviceman installer an
outlet near the appliance.
The power supply cord must be long enough for
connecting the appliance, once fitting in its housing,
to the main power supply.
For installation to comply with current safety
regulations, an omnipolar disconnect switch with
minimum contact gap of 3 mm must be utilized.
Prior to connecting
The appliance can be operated only if the
microwave oven door is firmly closed.
The earthing of this appliance is compulsory. The
manufacturer will accept no responsibility for injury
to persons, animals or damage to objects arising
from the non-observance of this requirement.
The manufacturers are not liable for any problems
caused by the user’s failure to observe these
instructions.
After installation, the bottom of the appliance must
no longer be accessible.
For correct appliance operation, do not obstruct
the minimum gap between the workshop and the
upper edge of the oven.
After connecting
