332847
16
Zoom out
Zoom in
Previous page
1/20
Next page
(See the product description sheet for model)
Remove the bottom of the hob, lifting out the installation
brackets to change the dual crown wok burner injector. Please
contact the Customer Care Centre.
REMOVING THE MAIN INJECTOR
Remove the injector (F) using a 10mm spanner. Slacken the
holding screw (H) to regulate the position (X) of the gas inlet
coupling (G) with regard to the injector.
REMOVING THE SECONDARY INJECTOR
Remove the injector (I) using a 12 mm spanner. There is no need
to regulate the position (Y) of the gas inlet coupling (L) with
regard to the injector. Leave it at end stroke, corresponding with
the sizes shown in the injector table.
FITTING THE WOK BURNER
To fit the dual crown burner wok, insert in the following order:
the burner ring (A), the decorative covering ring (B), the external
burner cap (C) and the internal burner cap (D).
Replacing the injectors
To ensure the minimum level is properly regulated, remove the
handle and work on the screws found on the tap as follows:
tighten to reduce the height of the flame (-)
slacken to increase the height of the flame (+)
Regulating the minimum level must be done with the tap at the
lowest position (small flame) .
- There is no need to regulate the primary air in the burners.
- With the burners on, rotate the buttons from the maximum
to the minimum position to check the stability of the
flame.
Once you have finished regulating, close up the seals again using
sealing wax or similar.
Regulating the minimum level of the taps
16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KitchenAid khmf 9010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KitchenAid khmf 9010 in the language / languages: English as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KitchenAid khmf 9010

KitchenAid khmf 9010 User Manual - German - 20 pages

KitchenAid khmf 9010 User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info