1. Removing the packaging and controls:
• After unpacking, make sure that the dishwasher
is undamaged and that the door closes correctly.
If in doubt, contact a qualified technician or your
local retailer.
• Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
• This dishwasher has been factory tested to
ensure it functions correctly.
Such testing may leave slight water marks that
will disappear with the first wash.
2. Water and electrical connections:
• All water and electrical connections must be
carried out by a qualified technician in
compliance with the manufacturer’s instructions
(refer to the enclosed installation booklet) and
current local safety regulations.
• The appliance must only be used in the
household for the prescribed uses.
• Do not use the dishwasher if it has been
damaged in transit. Consult your local retailer
or our After-Sales Service.
(Refer to the separate installation
instructions booklet)
3. Water inlet and drain:
• Observe any special regulations issued by your
local Water Board.
Water supply pressure: 0.03 - 1.0 MPa.
• Make sure the inlet and drain hoses are kink-
free and are not crushed.
• If the hose length is not sufficient, please contact
your local dealer or our After-Sales Service.
• The inlet hose must be securely clamped to the
water tap to prevent leaks.
• The inlet water temperature varies according to
the model installed. Inlet hose marked “25°C
Max”: maximum temperature 25°C.
All other models: maximum temperature 60°C.
• When installing the appliance, make sure the
drain water discharges correctly (if necessary,
remove the wire gauze from the sink siphon).
• Fix the drain hose to the spigot with a clamp to
prevent it from coming off during operation.
For appliances with water-stop system only: If
the water connections are made correctly, the
waterstop system safeguards your home against
damage caused by flooding.
4. Electrical connection:
• Closely adhere to local Electricity Board
regulations.
• Voltage information is shown on the rating plate
mounted inside the door on the right hand side.
• The appliance must be earthed as
prescribed by law.
• Do not use extension leads or multiple
adapters.
• Before carrying out maintenance, disconnect
the mains plug.
• If necessary, the power cable may be replaced
with one the same obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
Warning for models provided with LCD
display:
The mains plug must be positioned in an
easily accessible place.
• For Austria: if the apparatus is series
connected to a fault current switch, this must
be sensitive to the pulsating current.
EC Declaration of conformity
This appliance has been designed, constructed and
distributed in compliance with the safety
requirements of EC Directives:
• the safety objectives of Low Voltage Directive
2006/95/EC (replacing 73/23/EEC and
subsequent amendments);
• 89/336/EEC
• 93/68/EEC
Load capacity: 12 place settings.
Before using the dishwasher/connections
4
