581376

KitchenAid 720-0733 Manual

24
Zoom out
Zoom in
Previous page
1/112
Next page
24
Check and Adjust the Burners
The burners are tested and factory-set for most efficient
operation. However, variations in gas supply and other conditions
may make minor adjustments to air shutter or low flame setting
necessary.
It is recommended that a qualified person make burn
er
adjustments.
NOTE: The rotisserie burner cannot be adjusted.
Checking and adjusting the grill burner flames requires removing
the grates and flame tamers.
Burner Flame Characteristics
The flames of the grill burners and side burners (on some models)
should be blue and stable with no excessive noise or lifting (LP
gas flames will have a slightly yellow tip). A yellow flame indicates
not enough air. If flame is noisy or lifts away from the burner, there
is too much air. Some yellow tips on flames when the burner is
set to HIGH setting are acceptable as long as no carbon or soot
deposits appear. The flames should be approximately 1" (2.5 cm)
high
.
Check
that burners are not blocked by dirt, debris, insect nests,
etc
., and clean burners as necessary. If they are clean, adjust air
shutters as needed.
IMPORTANT: B
efo
re adjusting air shutters, let burners cool
completely.
To Adjust:
1. Light grill using information in the “Outdoor Grill Use” section.
2. Observe flame to determine which burners need adjustment
and how
the flame is acting.
3. Turn off the valve and wait until grill and burners cool
completely.
4. R
emove grill grates and flame tamers.
5. Remove the 1 screw and cotter clip that hold the burner in
the plac
e. Remove gas burner from the grill.
6. If flame is
yellow (not
enough air), turn air shutter adjustment
screw counterclockwise.
If flame is noisy or lifts away from burner (too much air), turn
air shutter
adjustment scr
ew clockwise.
Adjustment should be made cl
ockwise or
counterclockwise
from ¹⁄₈" (3.2 mm) to ¹⁄₄" (6.4 mm).
7. Replace gas burner, flame tamers and grates.
8. Light grill using information in the “Outdoor Grill Use” section.
See “B
urner Flame Characteristics.”
Low Flame Adjustment
If flame goes out on the “LOW” setting, the low flame setting
must be adjusted.
1. Turn off the valve and wait until grill and burners are cool.
2. Remove grill grates and flame tamers.
3. Light grill using information in the “Outdoor Grill Use” section.
4. Turn burner to its lowest setting.
5. Remove each control knob for the
main burn
er and side
burner.
6. Hold valve stem with pliers and insert a small flat-blade
screwdriver into
the shaft.
7. Watch the flame and slowly turn the screwdriver
counterclockwise.
8. Adjust flame to minimum stable flam
e.
9. Replace the control knob and turn off the burner.
10. Repeat
steps 3 through 9 for each burner if needed.
11. Repla
ce the flame tamers and grates after the burners have
cooled.
A.Cotter clip
1" (2.5 cm)
A
A. Air shutter adjustment screw
A. Valve stem
B. Small flat-blade screwdriver
C. Pliers
A
A
B
C
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KitchenAid 720-0733 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KitchenAid 720-0733 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 26,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info