713579
19
Zoom out
Zoom in
Previous page
1/48
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
19
TKG CCG 1000 - 141121
Assembly page 19/48
Fax +32 2 359 95 50
Never forget to close the lid of the water tank before switching on your coffee maker.
Check that your appliance is in the "coffee powder" mode and not in the "coffee mill"
mode. To do so, check that the indicator lamp of the coffee powder mode selector
switch is lit.
Switch on the coffee maker with the ON/OFF switch. The pilot light of the switch will be
illuminated, indicating that your appliance works.
When the coffee stops flowing, you will hear 3 beeps, the keep warm indicator lamp will
start flashing and the appliance goes to the keep warm mode for 2 hours before it
switches off automatically.
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
PROGRAMMING THE COFFEE MAKER
You can programme your coffee maker to brew fresh coffee at a preset time, both in the
coffee powder mode and in the coffee mill mode.
To do so, proceed as follows:
Make sure the coffee maker’s clock is set to the right time.
Press on the programming button until the timer symbol flashes.
Press the buttons for the hours and the minutes to set the desired brew time.
When the brew time is set, and as the timer symbol is flashing, choose the coffee
powder mode or the coffee mill mode.
If you choose the coffee mill mode (indicator lamp of the coffee powder mode
selector switch off), select the number of cups and the desired aroma and
confirm the programming by pressing the programming button. The timer
symbol will then be steadily illuminated.
If you choose the coffee powder mode (indicator lamp of the coffee powder
mode selector switch lit), confirm the time programming directly by pressing the
programming button. The timer symbol will then be steadily illuminated.
Once the programming has been confirmed, the LCD display shows the actual time
again. If you have chosen the coffee mill mode, the LCD display will show the number of
cups and the aroma of the last use and not the ones of your programming once the clock
mode is back. Do not worry as long as the timer symbol is lit, the programming is well
registered.
Attention: if you do not confirm the programming or if you do not press any key within 7
seconds, the brew time will be saved in the memory but the coffee maker will not be in the
programming mode.
Pour the right amount of water into the water tank, put a filter into the filter holder and
add coffee powder (into the filter) or coffee beans (into the coffee bean compartment)
according to your programming choice. In both cases, the procedure is the same as for a
manual use except that you do not have to press the ON/OFF switch.
When your preset brew time is reached, the coffee maker will start its brew cycle in the
same way as with the manual use.
As with the regular brew cycle, an automatic two-hour keep-warm cycle will commence
after your coffee maker has finished brewing. When the 2 hours are over, the coffee
maker will automatically shut itself off.
If you wish to delete a programming, press the programming button until the timer symbol
goes out.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kitchen Originals TKG CCG 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kitchen Originals TKG CCG 1000 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info