741706
7
Zoom out
Zoom in
Previous page
1/26
Next page
Setting up your Blood Pressure Monitor
Putting on the Cuff
a. Place the cuff 1~2cm above the elbow joint.
Measuring can be done on light clothing such as a
shirt or blouse. However, if you have a weak
pulse, it is recommended you test on a bare arm.
Remove any tight or restrictive clothing from your
arm. For example, restriction caused by rolling up
shirt sleeve.
b. Place hand on a flat surface with the palm
facing up and with the rubber tube running
down the center of the arm.
The cuff can be cleaned by hand with warm,
soapy water. Rinse thoroughly with cold water
and towel dry.
DO NOT IRON.
d. Use your free hand to adjust the
tightness of the cuff until it is firm.
To get the correct tightness of the cuff, you should
be able to fit two fingers under the cuff.
Concerned about which arm to use?
Please refer to ‘Your first test’ on page 6.
c. Turn the cuff end outwards and tighten it
by pulling it through the metal loop and
pressing the hook surface of the cuff on
to the loop surface of the cuff.
6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kinetik BPx1A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kinetik BPx1A in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info