Manual Kicker XS100 (page 4 of 12) (English)

508887

Zoom out

Zoom in

1/12

WIRING INSTRUCTIONS

All speaker connectors will accept up to 8 gauge wire, and the power and ground con-

nectors are designed for 4 gauge wire. It is very important that the screws in the ampli-

fiers’ terminal strips are very tight. An allen wrench is included for this purpose. Always

make the ground connection first when installing this amplifier and disconnect ground last

when removing it from the system.

Connect the ground wire, which is 24 inches or less, to a structural chassis member. Be

sure the connection is to bare metal and securely screwed or bolted. (It is not recommend-

ed to run the ground wire to the battery.) Run a positive wire of the size shown below

directly to the positive terminal of the battery and use a fuse of appropriate size within 18

inches of the battery.

This fuse protects the wire run from the battery.

Please refer to this wire gauge selection chart for minimal loss at full rated power under

test conditions:

Model Up to 4 ft 4 to 7 ft 7 to10 ft 10 to 13 ft 13 to 16 ft 16 to 22 ft

XS50 6 6 4222

XS100222200

When running the signal wires keep them away from all power wires in the vehicle to avoid

noise. If a signal wire needs to cross power wires, try to make the junction at 90 degrees.

This will have the least chance of picking up noise.

Note: in the case where the recommended wire size is larger than the amplifier’s connec-

tor, it may be necessary to use a power distribution block or inline connector to adapt

down to the size your amp will accept.

Inline fuse used at the battery: XS50 = 90A, XS100 = 150A (supplied with the amplifier).

IMPORTANT INFORMATION

PLEASE READ BEFORE INSTALLING AMPLIFIER

Your new KICKER power amplifier is equipped with a ZRX Active Electronic Crossover

Module installed in the Module Docking Port.

You may configure the ZRX to function as a low pass filter (12dB/octave at 80Hz) or

high pass filter (12dB/octave at 100Hz) by setting the switch on the ZRX as shown is the

illustration. The ZRX may also be set to bypass, in which case your amplifier will function in

a full-range mode. The ZRX affects only the amplifier in which it is installed. The amplifier’s

output RCA jacks carry a full-range signal regardless of the settings on the ZRX.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kicker XS100 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kicker XS100 Manual

Product: