508849
9
Zoom out
Zoom in
Previous page
1/16
Next page
9
KX Amplifiers
Help
Trouble Shooting
If your amplifier does not appear to be working, check the
obvious things first such as blown fuses, poor or incorrect wiring
connections, incorrect setting of crossover switch and gain
controls, etc.
There are two LEDs on the end panel of your Kicker KX series
amplifier, one green and one red. When the green LED is lit this
indicates the amplifier is turned on and no trouble exists. If the
green LED turns off and the red LED is lit, this indicates that the
protection circuitry (SORT) is engaged.
The power indicator on top of the amplifier which illuminates
the model badge follows the same function as the green LED,
indicating the amplifier is turned on and no trouble exists.
Green LED off, no output:
With a Volt Ohm Meter (VOM) check:
+12 volt power terminal (should read +12V to +16V).
Remote turn-on terminal (should read +12V to +16V).
Check for reversed power and ground connections.
Ground terminal, for proper conductivity.
Green LED on, no output:
Check RCA connections.
Test speaker outputs with a “known” good speaker.
Substitute source unit with a “known” good source unit.
Check for a signal in the RCA cable feeding the amplifier
with the “AC” test position selected on the VOM meter.
Red LED on, no output:
1.) Amp is very hot.
Thermal protection is engaged. Test for proper
impedance at the speaker terminals (see the diagrams in
this manual for minimum recommended impedance and
multiple speaker wiring suggestions) with a VOM meter.
Also check for adequate airflow around the amplifier.
2.) Amp shuts down only while vehicle is running.
Voltage protection circuity is engaged. Voltage to the
amplifier is not within the 9-16 volt operating range. Have
the vehicle’s charging and electrical system inspected.
3.) Amp will only play at low volume levels.
Short circuit protection is engaged. Check for speaker
wires shorted to each other or to the vehicle chassis.
Check for damaged speakers, or speaker(s) operating
below the minimum recommended impedance.
No output from one channel:
Check the balance control on source unit.
Check RCA & speaker connections for the channel.
Swap the RCA connections from left to right.
If problem changes sides then you have a bad RCA cable
or source unit problem.
Swap speaker connections from left to right.
If problem changes sides then you have a bad speaker
cable, passive crossover network and/or speaker.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kicker KX 250.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kicker KX 250.2 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kicker KX 250.2

Kicker KX 250.2 User Manual - German - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info