166250

Kicker ix 406 impulse Manual

9
Zoom out
Zoom in
Previous page
1/12
Next page
Adjustments and Controls
Setting Gain Control
The gain control is provided for level matching purposes. The control does not give the amplifier any more
power by turning it up. Its purpose is to adjust the sensitivity of the amplifier in relation to the output level provid-
ed by the source.
Start with the amp gains set to minimum by turning the controls counter-clockwise. Turn the source level up
until distortion is barely audible. Then turn the source down slightly. This will typically be at about 85 to 95% of full
volume. Raise the front amplifier gain control until distortion is just audible in the front speakers. Now the deck is
matched to the front amplifier channels. Turn the source down to a realistic listening level.
Turn the rear amplifier gain control up until the desired front/rear balance is achieved.
Turn the sub amplifier gain control up to provide the bass level desired.
Note: As the KICKEQ controls are turned up to provide additional bass or treble, the overall signal goes up. It may
be necessary to readjust the gain controls if the KICKEQ controls are turned up very much.
Setting KICKEQ™ Controls
The Bass and Treble controls on your Impulse Amplifier are provided to help tune your system for ideal sound
quality. After the system is installed and the vehicle is put back together, do a listening test with music that is typi-
cal of the type you normally listen to.
Initially set the tone controls on the source unit to flat and turn the KICKEQ™ controls fully counter-clockwise.
Depending on your personal taste and the speakers used in the system, you may want to increase the high or low
frequencies by turning the KICKEQ™ controls clockwise. Remember that once the vehicle is in motion there will be
an apparent loss of bass due to the masking effect of road noise. Do not attempt to make adjustments while the
vehicle is in motion. It is safer to pull off the road to make changes.
Never change the crossover settings while the amplifier is on. A loud pop will result which could destroy speakers
or cause hearing loss.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kicker ix 406 impulse at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kicker ix 406 impulse in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info