578853
9
Zoom out
Zoom in
Previous page
1/34
Next page
8
9
Adding Water
The LCD Control Center of your Brewer will
indicate when the water level in the Water
Reservoir is low or if the Water Reservoir has
been removed by displaying the words ADD
WATER” (fig. 8). The blue light in the Water
Reservoir will also blink when water needs to
be added. The Brewer will not allow you to brew
whenADD WATER” is displayed.
The Water Reservoir can be filled in two ways.
1. Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer,
then replace the Lid.
2. Remove the Water Reservoir from Brewer by first removing Lid from
the Water Reservoir, then lifting the Water Reservoir straight up and
away from Brewer. Fill with water. Place the Water Reservoir back on
the Brewer and replace the Lid.
IMPORTANT: Do not remove the Water Reservoir during the
brewing process.
Brewing Hot Water
Your Brewer is able to produce hot water for making hot cocoa from a packet,
for use in cooking, for making soups, etc. Simply raise and lower
the Handle on the Brewer without adding a K-Cup. The LCD Control Center
will display “READY TO BREW” and the Small Cup, Small Mug and Large
Mug Buttons will blink. Be sure to have a mug or cup on the Drip Tray Plate
and then select the size you would like.
NOTE: After brewing a hot cocoa K-Cup, we recommend running a hot water
brew cycle without a K-Cup.
Purging the Brewer
If your Brewer has not been used for more than one week, you should purge
the water from the inner tank.
1. If there is water in the Water Reservoir, remove the Lid, then lift the
Water Reservoir straight up and away from Brewer. Discard water, rinse
and refill with water. Place the Water Reservoir back on the Brewer and
replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
2. Be sure the Brewer is turned on. Raise and lower the Handle on the
Brewer without inserting a K-Cup.
3. The LCD Control Center will display “READY TO BREW” and the Small Cup,
Small Mug and Large Mug Buttons will blink. Be sure to have a large mug
on the Drip Tray Plate and then select the Large Mug size brew.
4. Repeat steps 2 and 3 one more time to completely purge water from
inner tank.
If you are experiencing any problems with your Brewer, please contact
Customer Service at 1.866.901.BREW (2739).
ADD
WATER
NOT READY
fig.
8
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Keurig B60 Special Edition at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Keurig B60 Special Edition in the language / languages: English as an attachment in your email.

The manual is 2,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info