457813
19
Zoom out
Zoom in
Previous page
1/104
Next page
ST 7609-68
19
GB
damage people’s health. Recycling of materials conserves pre-
cious raw materials. When disposing of the appliance, remove
all batteries and storage batteries from the product and hand
them over to the collection point for the recycling of batteries or
electrical or electronic appliances. Information about the appro-
priate collection points can be obtained from your local authori-
ties, your waste disposal team or in the outlet where this appli-
ance was sold.
Possibilities for Pulse Measurement
The pulse measurement starts as soon as the heart in the display
blinks in time with your pulse beat.
With ear clip
The pulse sensor works with infrared light and measures the
variations in translucence in your skin, which are produced by
your pulse beat. Rub your ear ten times strongly to activate the
blood circulation before attaching the pulse sensor to your ear-
lobe. Avoid disturbing pulses.
Attach the ear clip properly to your earlobe and look for the
best point for the measurement (heart symbol blinks without
interruption).
Do not train directly under strong incidence of light, e.g.
neon light, halogen light, spotlight, sun light.
Completely eliminate any shocks or bounces of the ear sen-
sor and the cable. Always attach the cable with a clip at
your clothing or, even better, at your headband.
With chest strap
If a chest strap should be used optionally, the connection
between the chest strap and the training computer must be
established by using a plug-in receiver. Chest strap and plug-in
receiver can be ordered subsequently.
With hand pulse
An extra-low voltage caused by the contractions of your heart is
registered by the hand sensors and evaluated by the electronics
assembly of the device.
Always grab the contact faces with both hands.
Avoid jerky grasping.
Hold your hands calmly and avoid contractions and rubbing
on the contact faces.
Note:
Pulse measurement can be accomplished: by ear clip, by hand
pulse, or by chest strap. If there is no ear clip or plug-in receiver
in the pulse jack, hand pulse measurement is activated. If there
is an ear clip or plug-in receiver in the pulse jack, the hand
pulse measurement is automatically deactivated. There is no
need to pull out the connector of the hand pulse sensors.
Options for pulse measurement.
optional
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kettler ST7609-68 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kettler ST7609-68 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 10,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info