6
Operating instructions for the training computer
with digital display (7831)
1. Start without previous knowledge
You can begin with the training without previous knowledge.
In the display, the different information is shown. For an efficient
training and for setting your personal training specifications,
please read and follow these operating instructions.
Also read the general information in the training instructions.
Starting the device
Insert 2 batteries. (1,5 V UM 3/AA). The computer carries out
a segment test and shows all presentable signs. A beep sounds
for confirmation.
Afterwards the calendar display appears and the year display
blinks.
Designation Y = Year . With the key SET, select the current year.
If you have set the year too far, enter RESET: Start again with
2004. After confirmation with MODE, you reach the date
display to the left of this. Here
with SET in the same manner
enter the month (M=Month),
and after confirmation with
MODE the day (D=Day). In
turn MODE takes over the day
and switches to the large display time. Here also with SET and
MODE enter first the hour and then the minutes. After confirmation
of the minutes through the key MODE, you come in the settings
area of the functions.
The calendar and time settings remain stored until the batteries
must be changed.
2. Function keys
MODE
Through shortly pressing the MODE key, you
select between the functions [TIME, DISTANCE,
CALORIES or PULSE] both for the display as
well as for your personal settings.
If you press the MODE key for a longer time, all values are set
to >0<.
Functions and Operation of the Training Computer
SET
With the SET key, the standard values are set. For
this the device must be in idle state > shown in
the display in the upper left: STOP: Through
shortly pressing the SET key, the setting values of the differing
functions increases > [TIME; DISTANCE, CALORIES or PULSE].
If the SET key is pressed for a longer time, the setting values can
be reached in a quicker counting sequence.
RESET
With the RESET key, the functions are set to >0<.
With the input settings of the respective function,
only the value of these functions is set to >0< through shortly
pressing the RESET key. If the RESET key is pressed for longer
than 2 seconds, all values are set to >0<, this corresponds to
a new start of the computer.
When exchanging the batteries, all values are set back to >0<
as well.
RECOVERY
Use the RECOVERY key to activate the
recovery pulse function after exercising.
3. Functions – Display
General:
In the display respectively a large display and at the same time
several segment displays appear in the lower area next to
each other.
After finishing exercising, the exercise data remains and can
be called up when you begin exercising again. The new data
is then added to these.
Exception: The computer was set to >0< with RESET, in the
personal exercise presettings the value was set at >0< or the
batteries were changed.
–With an interruption of the exercising for 4 minutes, the
main screen is shut off.
– If the computer shows undefinable displays, take out the bat-
teries, replace them again and try it again.
SCAN
Alternating display of all functions in large display. Left in the
display respectively the designation
appears in a shortened form:
RPM = Round Per Minute = Rota-
tions per minute / pedal frequency
SPD = SPEED
TM = TIME = Exercise time
DST = DISTANCE = distance
covered
CAL = CALORIES = Energy,
calorie consumption
PLS = PULSE = Pulse frequency
If the large display with the respec-tive unit appears, the fun-
ction des-cription blinks in the small window.
RPM /SPEED (left)
In this display, at turning intervalls (every 6
seconds), the pedaling frequency as RPM
(=rotations per minute) and the speed SPEED
in km/r are shown. The highest speed is
99.9 km/h.
GB
7831
