Manual Kettler Run 7 - 07883-600 (page 12 of 84) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish)

736639

Zoom out

Zoom in

1/84

INCLINE ADJUSTMENT

With the INCLINE button (+) the incline angle will be increased by

0,5 %.

With the INCLINE button (-) the incline angle will be decreased by

0,5 %.

Pressing and holding of this button leads to an automatic fast run

through the values.

SPEED ADJUSTMENT

ith the SPEED button (+) the speed can be increased during the

raining by 0.1 km/h (mph).

With the SPEED button (-) the speed can be decreased during the

training by 0.1 km/h (mph).

Pressing and holding of this button leads to an automatic fast run

through the values.

PULSE RECEPTION

The treadmill is equipped with a hand pulse detection. To gua-

rantee a good hand pulse detection both hand pulse sensors shall

be firmly and entirely covered by the hands without moving the

hands. Movements of the hands can lead to interferences. The

pulse display requires approx. 5 to 15 seconds to show your cur-

rent pulse.

The treadmill also comprises of an in-built POLAR compatible

heart rate receiver. To be able to use the wireless pulse system you

need to wear a chest strap for the transmission of the heart rate.

The chest strap for the transmission of the heart rate is not inclu-

ded in the scope of supply of this treadmill. We recommend the

POLAR Chest Strap T34. This can be purchased as additional

equipment in specialist shops.

Please remember that some materials used in your clothes (e.g.

polyester, polyamide) can cause electrostatic charging and possi-

bly prevent an accurate heart rate measurement. Please also con-

sider that mobile phones, televisions and other electrical devices

that create an electromagnetic field around them, might also

cause problems with the measurement of the heart rate.

ERROR MESSAGES

During the operation different messages will be shown in the dis-

play in case of an error of the control. Error messages can be

reversed by switching off and restarting of the power supply. If the

error message remains, contact the customer support.

MODE

TURN ON

First of all turn on the treadmill. The ON/OFF switch (I/O) for the

treadmill is located next to the mains cable on the front under-

neath the motor cover. Flip the switch to the "ON" setting = (I).

The total kilometres are displayed with odo XXXX.

SAFETY KEY

Always check that the safety switch works before every training

session. Insert the safety key into the safety switch and the cord to

your clothing. If the safety key is not inserted in the safety switch,

"SAFE - - - SAFE" appears on the display.

START TRAINING

Always hold on tight to the handrails when getting on and off the

treadmill.

Stand on the treadmill's side platform before you start training.

Never start the treadmill while you are standing on it. Start your

training with a slow speed and then increase the speed or incli-

ne. Always run in the middle of the treadmill if possible.

Always keep your body and head facing forwards during the trai-

ning session. Never try to turn around on the treadmill while it is

moving.

TRAINING OPTIONS

MANUAL

Once the treadmill is turned on and the safety key is engaged

press the START key. The treadmill will start after 3 seconds with

0,8 km/h (0,5 mph).

You can increase / reduce the speed or incline at any time during

the training session. To end the training session press the STOP

key.

When you manually start the training session, the training

distance and time display counts upwards. The manual program

is a training session with no time limit.

1. Turn on the treadmill.

2. Secure the safety key to the treadmill and the clip to the

user's clothing.

3. Press the START key to start training.

MANUAL with time or distance input

Press the TIME or DISTANCE key before training. The relevant key

lights up bright. Input the values using the (-/+) keys. The TIME or

DISTANCE display counts down at the start of the training sessi-

on.

PULSE CONTROLLED

(key only lights up bright with pulse signal)

Target pulse before training (60 - 200)

Press the PULSE key. The display flashes. Input a value using the (-

/+) keys. Press the PULSE key again to confirm. During training,

the target pulse is controlled and held by adapting the speed and

incline (option) once the current pulse is in the range of -/+ 15

beats from the target pulse for at least 30 seconds. The speed can

be manually adjusted outside this range.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kettler Run 7 - 07883-600 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 2,97 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kettler Run 7 - 07883-600

Kettler Run 7 - 07883-600 Installation Guide - English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish - 40 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kettler Run 7 - 07883-600 Manual

Product: