565545
108
Zoom out
Zoom in
Previous page
1/116
Next page
108 English
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight misoperation or
miswiring. Before calling service, first check the following table for possible problems.
General
The power does not turn on.
The fuse has blown.
The desired source is NOT selected although you pressed the SRC button.
An optional unit required to listen to each source is
not connected yet.
The RESET button is not pressed yet although the
optional unit has been connected to the system.
The "O-N" switch of the optional unit is at the "O"
position.
•A disc changer not supported by the system is used.
Nothing happens when the buttons are pressed.
The computer chip in the unit is not functioning
normally.
No television/video image appears.
The unit is not connected to the parking brake
detection switch.
The parking brake is not engaged.
The screen is dark.
The unit is in a location where temperature is low.
The screen does not darken when the vehicle’s lights are turned on.
The unit is set to auto dimmer.
The illumination wire has not been connected. (If
manual dimmer is set)
AM/FM radio reception is poor and/or there is noise.
The TV antenna and vehicle‘s radio antenna are too
close.
The remote controller does not operate.
The remote control mode selector is not set
correctly.
After checking for short circuits in the wires, replace the
fuse with one having the same rating.
•A non-connected source is not selected. See <Connection>
(see page 94) and connect the unit correctly.
Press the reset button (see page 4).
Set the "O-N" switch to the "N" position.
Use a disc changer supported by the system (see page 4).
Press the reset button on the unit (see page 4).
Make proper connections according to <Connections>
(see page 98).
For safety reasons no television/video images are
displayed while the vehicle is moving. Engaging the
parking brake will cause images to be displayed.
If the temperature of the monitor unit drops, the screen
may appear darker when power is first turned on due to
the characteristics of a liquid crystal panel. Wait a while
after turning power on for the temperature to rise. Normal
brightness will return.
When the unit is set to auto dimmer, it is not linked to the
vehicle's light switch.
Make proper connections according to <Connections>
(see page 98).
Separate the two antennas as far as possible.
Turn off the main unit.
Switch the remote control mode selector according to the
source you select (see page 12).
108


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood XXV-05V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood XXV-05V in the language / languages: English as an attachment in your email.

The manual is 15,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood XXV-05V

Kenwood XXV-05V User Manual - German - 104 pages

Kenwood XXV-05V User Manual - Dutch - 104 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info