XD SERIES (En/E2)
33
Preparation section Basic section Application section Knowledge sections
Selection of DOLBY NR (Noise Reduction)
The Dolby NR system minimizes the hiss noise heard when
playing tape.
To end recording
Selection of the reverse mode
÷ Pressing the key pauses recording after leaving a non-recorded
space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it has been
pressed, recording resumes from that instant.
÷ Recording can also be stopped by pressing the stop (7) key.
However, the non-recorded section is not left in this case.
1Start recording.
2Play (or tune) the input source to be
recorded.
4. Select the source to be recorded.
5. Start recording.
÷ When the CD input is selected and if a disc
has been set in the CD player, its playback
starts immediately. Press the stop (7) key to
stop the playback.
Let's record
Select an input source other than “TAPE”.
÷ Recording stops automatically when the tape
side(s) to be recorded have been fully re-
corded.
Lights
REC / ARM
1
7
2
To let recording pause temporarily (Pause)
÷ Press the REC/ARM key to resume recording.
8
PAUSE
Lights
REV.MODEDOLBY NR
Each press switches the modes as follows.
1 “DOLBY NR indicator” ON
........ DOLBY NR is used.
2 “DOLBY NR indicator” OFF
........ DOLBY NR is not used.
Each press switches the modes as follows.
1 “[”... Both sides are recorded, and then the tape
stops (If direction 2 is selected, only the
back side of tape will be recorded.).
2 “”” .. Both sides are recorded (If direction 2 is
selected, only the back side of tape will be
recorded.).
3 ““” .. Only one side is played back (recorded),
and then the tape stops.
REV.MODEDOLBY NR
Lights up
(when CD input is selected)
Note
Note
If you want to use one of “Convenient
recording functions”, make preparation
until this stage.
p
AUX MD TAPE TUNER CD
44
Select the input source to be recorded.
REC / ARM
55
UNER CD
When the recorded sound level is too low or too high causing
distortion, it is possible to adjust the recording level manually.
›
