683161
187
Zoom out
Zoom in
Previous page
1/196
Next page
Symptom Probable Cause Corrective Action Refer to
The USB flash drive cannot be
recognized.
The USB flash drive is not formatted by this
transceiver.
Format on this transceiver.
11-5
Poor connection. Connect the USB flash drive. 1-2
The USB flash drive is security-enabled. This transceiver does not support security-
enabled USB flash drive.
11-1
The USB flash drive is damaged. Check on the PC to determine whether the USB
flash drive connected to this transceiver is
functioning properly.
The USB flash drive in use does not conform to
the USB specifications.
Use a USB flash drive that conforms to the USB
specifications.
11-1
Multiple USB flash drive devices are
connected.
Use only the USB flash drive that is first
recognized by this transceiver.
The file system of the USB flash drive is
corrupted.
Format on this transceiver.
11-5
Unable to write files to the USB flash
drive.
The USB flash drive is write-protected. Remove the write protection.
The USB flash drive is not formatted by this
transceiver.
Format on this transceiver.
11-5
Poor connection. Reconnect the USB flash drive. 1-2
The USB flash drive is security-enabled. This transceiver does not support security-
enabled USB flash drive.
11-1
The USB flash drive is damaged. Check on the PC to determine whether the USB
flash drive connected to this transceiver is
functioning properly.
The USB flash drive in use does not conform to
the USB specifications.
Use a USB flash drive that conforms to the USB
specifications.
11-1
The file system of the USB flash drive is
corrupted.
Format on this transceiver.
11-5
There is no remaining space available. Use a USB flash drive with sufficient remaining
space.
There are too many files in a folder. Not more than 255 files can be stored in each
folder. Delete the unwanted files and before
saving.
11-1
USB flash drive formatting failed. Formatting of the USB flash drive started while
<< >> was blinking and formatting failed.
Follow the procedures in Safely Removing the
USB Flash Drive” (11-6) to safely remove the
USB flash drive followed by inserting it again to
format it.
11-5
Steps to safely remove the USB flash
drive failed.
Safe removal failed for some unknown reason. Turn off the power of this transceiver and
remove the USB flash drive.
Some data may not be saved depending on the
data processing status of this transceiver.
11-1
<< >> continues to blink for
several minutes.
The USB flash drive is not recognized by this
transceiver.
Format on this transceiver.
11-5
No output to the external monitor. The output of the external display is OFF. Configure the output of the external display to
ON in Advanced Menu [21].
16-7
No output to the external monitor
during startup.
Depending on the specifications of the monitor
in use, delay in the display may occur when this
transceiver is powered on.
Wait for the startup screen of this transceiver to
disappear.
No output to the external monitor.
Display Off is selected for the screen saver
type.
Configure the screen saver type to “Off”.
RX audio from the PC cannot be heard
(during USB/ACC 2 connection).
The microphone setting on the OS is configured
to monaural.
When using a Windows PC, wait for the PC to
recognize this transceiver, then select Control
Panel → Hardware and Sound → Sound →
Recording Microphone (USB Audio CODEC)
Properties, followed by selecting “2 channel”.
TROUBLESHOOTING 18
18-7
187


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TS-890S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TS-890S in the language / languages: English as an attachment in your email.

The manual is 21,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TS-890S

Kenwood TS-890S User Manual - German - 196 pages

Kenwood TS-890S User Manual - Dutch - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info