682841
65
Zoom out
Zoom in
Previous page
1/89
Next page
59
SO-2 TEMPERATURE-COMPENSATED
CRYSTAL OSCILLATOR (TCXO)
CAUTION:
SWITCH OFF THE POWER AND UNPLUG THE DC
POWER CABLE BEFORE BEGINNING INSTALLATION.
1 Remove the bottom case (8 screws).
2 Remove the protective cover installed on the PC
board (6 screws).
3 Remove the 13 screws that fasten the PC board to
the chassis.
4 Remove the clamp that fastens the heat sink to the
chassis.
5 Remove the cable from the CN1 connector.
6 Take the CN1 connector cable off the cable holder.
7 Cut the leads of the R503 and R504 resistors.
8 Insert the SO-2 unit into the specified position on the
PC board.
9 Turn the PC board over.
Be careful not to damage the flat cables
connected to the PC board, and not to drop the
SO-2 unit.
10 Solder the five pins of the SO-2 unit to the PC board,
then cut off the SO-2 pins extruding from the PC
board.
11 Re-position the PC board.
12 Re-install the 13 screws on the PC board.
13 Re-install the protective cover on the PC board
(6screws).
14 Re-position the clamp.
Be careful with the orientation of the clamp. See
the drawing in step 4.
15 Reconnect the cable to the CN1 connector.
16 Pull the CN1 connector cable, and lock it using the
cable holder.
17 Replace the bottom case (8 screws).
14 INSTALLING OPTIONS
1
2
SO-2
Clamp
Heat sink
Cut here
CN1
R504
R503
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TS-570S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TS-570S in the language / languages: English as an attachment in your email.

The manual is 4,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info