511243
89
Zoom out
Zoom in
Previous page
1/104
Next page
81
INSTALLING OPTIONS
You will require a #1 Philips screwdriver to install the
VGS-1. To install the YF-107 IF filter(s) and/ or SO-3
TCXO, you will also need a soldering iron (approx.
30 watts).
REMOVING THE TOP COVER
When installing the optional VGS-1, YF-107 IF filters
or SO-3 TCXO, remove the top cover of the
transceiver:
1 Remove the 8 screws.
PADDLE KEY
EX
T.SP
DATA
REMO
TE
CO
M
MIC
PANE L
OPTION FILTER2
OPTION FILTER1
2 Lift off the top cover.
VGS-1 VOICE GUIDE & STORAGE UNIT
SWITCH OFF THE POWER AND UNPLUG THE DC POWER
CABLE BEFORE BEGINNING INSTALLATION.
1 Remove the top case (8 screws) {above}.
2 Loosen the 4 screws to remove the shield cover.
PA
DDLE
KEY
EXT.SP
DATA
REMOTE
COM
M
IC
P
A
N
EL
T
C
X
O
O
P
T
I
O
N
OPTION FILTER2
OPTION FILTER1
3 There are 5 rubber cushions in the VGS-1
package. Use the 2 rubber cushions shown below
and attach them to the VGS-1. The remaining
cushions are not used.
4 Plug the VGS-1 into the VGS-1 connector of the
PC board, pressing down on the top of the VGS-1
until secure.
PADDLE
KEY
E
X
T.S
PDA
TA RE
M
OTE
C
OM
M
IC
PA
NEL
T
C
XO
O
PT
IO
N
OPTION FILTE
R2
OPTION FILTER1
5 Replace the shield cover and tighten the 4 screws.
6 Replace the top case (8 screws).
Note:
After the installation, you can adjust the VGS-1 playback
volume by selecting Menu Nos. 14 and 15.
YF-107C/ CN/ SN IF FILTERS AND SO-3 TCXO
SWITCH OFF THE POWER AND UNPLUG THE DC POWER
CABLE BEFORE BEGINNING INSTALLATION.
Three different types of IF filters (YF-107C,
YF-107CN, and YF-107SN) are available for the
TS-480 transceiver. You can install a maximum of 2
IF filters in the transceiver. Refer to page 90 for the
bandwidth information on each filter. As for the SO-3
option improves the transceiver frequency stability to
±0.5 ppm.
1 Remove the top case (8 screws).
2 Locate the filter and TCXO PCB and loosen the
3 screws.
PADDLE
KEY
EXT.SP
DATA
REMOTE
COM
M
IC
P
A
N
E
L
OPTION FILTER2
OPTION FILTER1
T
C
X
O
O
P
T
IO
N
3 Unlatch the connectors by pressing the connector
tabs upwards.
PAD
DLE
KEY
EXT.SP
DATA
REMOTE
COM
M
IC
P
A
N
E
L
OPTION FILTER2
OPTION FILTER1
OPTION FILTER2
O
PTION FILTER1
TC
XO
O
PT
IO
N
T
C
X
O
O
P
T
I
O
N
4 Insert the IF filter(s) and/ or SO-3 TCXO.
OPTION FILTER2
OPTION FILTER1
TC
XO
O
PT
IO
N
VGS-1 connector
VGS-1 connector
VGS-1
IF filter/ TCXO PCB
SO-3
Calibration hole
Secondary IF filter
Primary IF filter
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TS-480SAT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TS-480SAT in the language / languages: English as an attachment in your email.

The manual is 6,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TS-480SAT

Kenwood TS-480SAT User Manual - German - 104 pages

Kenwood TS-480SAT User Manual - Dutch - 104 pages

Kenwood TS-480SAT User Manual - French - 104 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info