511237
12
Zoom out
Zoom in
Previous page
1/52
Next page
6
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to blow,
disconnect the power cable and contact your authorized Kenwood dealer or an
authorized Kenwood service center for assistance.
Fuse Location Fuse Current Rating
Transceiver
(located on the DC connector)
15 A
Supplied DC power cable 20 A
Only use fuses of the specified type and rating; otherwise the transceiver could be damaged.
Panel jack
MIC jack
Microphone
Operation panel
TX/ RX unit
Fuse holder (E type) Fuse holder (K, M4 types)
Fuse
Fuse holder
Fuse
Fuse holder
OPERATION PANEL AND MICROPHONE CONNECTION
Plug the microphone plug into the MIC jack, then connect the Operation panel to
the TX/ RX unit with the supplied cable.
Attach the microphone hanger to an appropriate position using the screws included in
the screw set.
Modular plug cable
Installing the Line Filter
Install the line filters
approximately 3 cm from the
connectors.
Approx. 3 cm
Line filter
Line filter
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TM-D710A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TM-D710A in the language / languages: English as an attachment in your email.

The manual is 2,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TM-D710A

Kenwood TM-D710A User Manual - German - 51 pages

Kenwood TM-D710A User Manual - Dutch - 51 pages

Kenwood TM-D710A User Manual - French - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info