606710
12
Zoom out
Zoom in
Previous page
1/81
Next page
5
1
REPLACING FUSES
If the fuse blows, determine the cause, then correct the
problem. After the problem is resolved, replace the fuse.
If newly installed fuses continue to blow, disconnect
the power cable and contact your authorized
Kenwood
dealer or an authorized
Kenwood
service center for
assistance.
reviecsnarTA51
yrosseccAdeilppuS
elbaCrewoPCD
A02
Fuse Location Fuse Current Rating
Only use fuses of the specified type and rating; otherwise the
transceiver could be damaged.
Note:
If you use the transceiver for a long period when the vehicle
battery is not fully charged, or when the engine is OFF, the battery
may become discharged, and will not have sufficient reserves to start
the vehicle. Avoid using the transceiver under these conditions.
ANTENNA CONNECTION
Before operating, install an efficient, well-tuned antenna.
The success of your installation will depend largely on
the type of antenna and its correct installation. The
transceiver can give excellent results if the antenna
system and its installation are given careful attention.
Use a 50 Ω impedance antenna and low-loss coaxial feed
line that has a characteristic impedance of 50 Ω, to match
the transceiver input impedance. Coupling the antenna
to the transceiver via feed lines having an impedance
other than 50 Ω reduces the efficiency of the antenna
system and can cause interference to nearby broadcast
television receivers, radio receivers, and other electronic
equipment.
Note:
E market models use an N-type antenna connector while
other models use an M-type (SO-239) connector.
Transmitting without first connecting an antenna or other
matched load may damage the transceiver. Always connect the
antenna to the transceiver before transmitting.
All fixed stations should be equipped with a lightning arrester to
reduce the risk of fire, electric shock, and transceiver damage.
Feed line connector
Antenna connector
To antenna
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TM-281A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TM-281A in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TM-281A

Kenwood TM-281A User Manual - German - 81 pages

Kenwood TM-281A User Manual - Dutch - 81 pages

Kenwood TM-281A User Manual - French - 81 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info