683138
54
Zoom out
Zoom in
Previous page
1/70
Next page
SIGNAL STRENGTH INDICATOR
The signal strength indicator displays the strength of received calls.
Strong signal
Sufficient signal
Weak signal
Very weak signal
Out of service range
(Appears on NXDN Trunking channels only)
BUSY CHANNEL LOCKOUT (BCL)
On Conventional channels, if BCL is set up by your dealer, you will be unable to
transmit on the channel if it is already in use. Under these circumstances, use a
different channel or wait until the channel becomes free.
However, if BCL Override has also been programmed, you can transmit over the
current signal:
1
Press and hold the PTT switch.
If the channel is already in use, a warning tone will sound.
2
Release the PTT switch, then press and hold the PTT switch again within half a
second.
3
Speak into the transceiver as you would during a normal call.
OUT OF RANGE
On NXDN Trunking channels, if set up by your dealer, the transceiver will indicate
when it is out of range. When it can no longer communicate with any site, an out of
range tone sounds and “Out of Range” appears on the display.
If enabled by your dealer, an In-service Tone will sound when an available control
channel is detected after the out of range tone has sounded. For details on the in-
service tone, consult your dealer.
NETWORK FAILURE
On NXDN Trunking channels, if set up by your dealer, the transceiver will indicate a
network condition on the registered site. “Network Fail” appears on the display when
the transceiver receives a network disabled message.
CONTROL CHANNEL HUNT
On NXDN Trunking channels, the transceiver must search for a control channel.
While searching for a control channel, no signals can be received. The search begins
automatically when you change to a Trunking channel.
While hunting for a channel, the antenna indicator will flash. When a control channel has
been found, the antenna indicator remains on the display without flashing.
54
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood NX-3000 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood NX-3000 series in the language / languages: English as an attachment in your email.

The manual is 9,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood NX-3000 series

Kenwood NX-3000 series User Manual - English, German, Dutch, French, Italian, Portuguese, Turkish, Spanish - 224 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info