606349
32
Zoom out
Zoom in
Previous page
1/48
Next page
18
Select “ALL” Fleet and “ALL” ID to make a call to all units
(Broadcast call).
Select “ALL” Fleet and enter an ID number to make a call to
the selected ID in all fleets (Supervisor call).
Note:
Broadcast and Supervisor calls are programmed functions that
cannot be made with a keypad.
The ID range may be limited by programming.
STATUS MESSAGE
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to
99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.
Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
mode (proceed to step 5) or Selcall + Status to enter
Selcall mode (proceed to step 3).
3 Press
/ to select the station you want to call.
If Manual Dialing is enabled, you can enter a station ID by
using the DTMF keypad, or by using / . When using
/ , cycle through the digits to select a digit, then
press to set the digit and move the cursor to the right.
Repeat this process until the entire ID is entered.
4 Press to enter Status mode.
5 Press
/ to select the status you want to transmit.
If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using / (refer to step
3, above).
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood NX-210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood NX-210 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info