630902
5
Zoom out
Zoom in
Previous page
1/27
Next page
the mixer
the mixing tools and some of their uses
beater
For making cakes, biscuits, pastry, icing, fillings, éclairs and mashed
potato.
flexible beater
For creaming and mixing soft ingredients. It is not to be used with
heavy recipes such as dough or hard ingredients.
whisk
For eggs, cream, batters, fatless sponges, meringues, cheesecakes,
mousses, soufflés. Don’t use the whisk for heavy mixtures (eg
creaming fat and sugar) - you could damage it.
dough hook
For yeast mixtures.
to use your mixer
1 Push up on the head release lever at the back of the appliance and
at the same time lift the head until it locks in the raised position.
to insert a tool 2 Line the pin on the shaft with the slot on the inside of the tool, push
up and turn clockwise to lock .
3 Fit the bowl onto the base, press down and turn clockwise to
lock .
4 Push up on the head release lever and at the same time lower the mixer
head .
5 Switch on and move the speed switch to the desired setting .
to remove a tool 6 Push up, turn anti-clockwise and pull off.
hints
Switch off and scrape the bowl with a spatula when necessary.
Eggs at room temperature are best for whisking.
Before whisking egg whites, make sure there’s no grease or egg yolk
on the whisk or bowl.
Use cold ingredients for pastry unless your recipe states otherwise.
When creaming fat and sugar for cake mixes, always use the fat at
room temperature or soften it first.
Your mixer has been fitted with ‘soft start’ feature to minimise
spillage. However if the machine is switched on with a heavy
mixture in the bowl such as bread dough, you may notice that the
mixer takes a few seconds to reach the selected speed.
points for bread making
important
Never exceed the maximum capacities on page 5 - you will overload
the machine.
To protect the life of the machine always allow a rest of 20 minutes
between loads.
Some movement of the mixer head is normal. If you hear the
machine labouring, switch off, remove half the dough and do
each half separately.
The ingredients mix best if you put the liquid in first.
At intervals stop the machine and scrape the mixture off the dough
hook.
Different batches of flour vary considerably in the quantities of liquid
required and the stickiness of the dough can have a marked effect
on the load imposed on the machine. You are advised to keep the
machine under observation whilst the dough is being mixed; the
operation should take no longer than 5 minutes.
4
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood MX313 Patissier at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood MX313 Patissier in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info