465256
60
Zoom out
Zoom in
Previous page
1/64
Next page
60
|
English
Troubleshooting Guide
General
?
The power does not turn on.
The fuse has blown.
After checking for short circuits in the wires,
replace the fuse with one having the same
rating.
The speaker wire has a short-circuit or touches
the chassis of the vehicle, and then the
protection function is activated.
Wire or insulate the speaker cable properly and
press the reset button.
?
The message "Disconnected cable found.
Please confirm a connection line." is displayed
and the unit cannot be used.
Receiver unit is disconnected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
?
A non-connected source cannot be selected.
An optional unit required to listen to each
source is not connected yet.
A non-connected source is not selected. See
<INSTALLATION MANUAL> and connect the
unit correctly.
The RESET button is not pressed yet although
the optional unit has been connected to the
system.
Press the reset button (see page 4).
The "O-N" switch of the optional unit is at the
"O" position.
Set the "O-N" switch to the "N" position.
A disc changer not supported by the system is
used.
Use a disc changer supported by the system
(see page 4).
?
Nothing happens when the buttons are
pressed.
The computer chip in the unit is not
functioning normally.
Press the reset button on the unit (see page 4).
?
No television/video image appears.
The unit is not connected to the parking brake
detection switch.
Make proper connections according to
<INSTALLATION MANUAL>.
The parking brake is not engaged.
For safety reasons no television/video images
are displayed while the vehicle is moving.
Engaging the parking brake will cause images
to be displayed.
?
The screen is dark.
The unit is in a location where temperature is
low.
If the temperature of the monitor unit drops,
the screen may appear darker when power is
first turned on due to the characteristics of a
liquid crystal panel. Wait a while after turning
power on for the temperature to rise. Normal
brightness will return.
?
The screen does not darken when the vehicles
lights are turned on.
The unit is set to auto dimmer.
When the unit is set to auto dimmer, it is not
linked to the vehicle's light switch.
The illumination wire has not been connected.
(If manual dimmer is set)
Make proper connections according to
<INSTALLATION MANUAL>.
?
AM/FM radio reception is poor and/or there is
noise.
The TV antenna and vehicle‘s radio antenna are
too close.
Separate the two antennas as far as possible.
Turn off the main unit.
?
The remote controller does not operate.
The remote control mode selector is not set
correctly.
Switch the remote control mode selector
according to the source you select (see page
10).
What might appear to be a malfunction in your unit may just be the result of slight misopera-
tion or miswiring. Before calling service, first check the following table for possible problems.
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood KVT-M707 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood KVT-M707 in the language / languages: English as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood KVT-M707

Kenwood KVT-M707 User Manual - German - 48 pages

Kenwood KVT-M707 User Manual - Dutch - 64 pages

Kenwood KVT-M707 User Manual - French - 64 pages

Kenwood KVT-M707 Installation Guide - All languages - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info