649661
18
Zoom out
Zoom in
Previous page
1/32
Next page
18
WIRE RACKS
Assemble the wire racks to the oven
walls using the 2 screws (Fig. 5.1).
• Slide in, on the guides, the shelf and
the tray (g. 5.2).
The shelf must be tted so that the
safety notch, which stops it sliding out,
faces the inside of the oven; the guard
rail shall be at the back.
• To dismantle, operate in reverse order.
Inside of oven: The oven should always
be cleaned after use when it has cooled
down. The cavity should be cleaned using
a mild detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used only on enamel after rst
consulting the instructions supplied with the
oven cleaner and testing a small sample on
the oven cavity. Abrasive cleaning agents
or scouring pads/cloths should not be used
on the cavity surface.
NOTE: The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention not to touch the hot heating
elements inside the oven cavity.
REPLACING THE OVEN LIGHT
WARNING: Ensure the appliance is
switched off before replacing the lamp
to avoid the possibility of electric shock.
Let the oven cavity and the heating
elements to cool down.
Switch off the electrical supply.
Unscrew the protective cover “C(g.
5.3).
Unscrew and replace the bulb “B
with a new one suitable for high
temperatures (300°C) having the
following specications: 230V, E14
and same power (check watt power
as stamped in the bulb itself) of the
replaced bulb.
Ret the protective cover “C”.
NOTE: Oven bulb replacement is not
covered by your guarantee.
B
C
Fig. 5.3
Fig. 5.1
Guard rail
Stop notch
Fig. 5.2
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood KS 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood KS 100 in the language / languages: English as an attachment in your email.

The manual is 6,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info